Abstract:A millisecond mixing process for liquids was implemented using a new mixer design, i.e., a jet nozzle connected with a trumpet-shaped module. The jet nozzle can facilitate two or three liquid channels, performing an initial impingement mixing of liquid sheets in the thickness at millimeters. Then, the joint liquids sheet out of the jet nozzle was stretched thinner and thinner on the expanded solid surface of the trumpet-shaped module, which significantly intensified the liquid mixing process. Accordingly, dual controls on the liquid mixing can be accomplished flexibly by optimizing the operating conditions and the module configuration. Experiments were carried out to investigate the influencing factors on the mixing performance, where the planar laser induced fluorescence (PLIF) technique was used to measure the mass transport of fluorescent dye between the liquids. The intensity of segregation (IOS) and 95% mixing time (τ95) were employed to characterize the mixing performance. The results showed that the module with a greater curvature surface possessed a better mixing performance owing to the rapid reduction of the liquid sheet thickness, which strengthened the mixing process in the lateral direction along the flow development. The mixing behaviors are greatly influenced by the flow rate ratio between the liquids. An optimum mixing state could be achieved when QS1/QS2 is 1:1. An increase of QT under the same flow rate ratio does not affect the mixing pattern in space, but the corresponding τ95 is almost linearly shortened. By splitting one liquid stream into two surrounding streams, the so called Sandwich operation brought further improved mixing performance compared with the two liquids mixing process. Using the novel jet nozzle design, millisecond(s) mixing of liquids can be easily achieved with flexible control.

Liquid-liquid fast-mixing reactor

Hydrodynamics in a Novel Gas-Liquid Cocurrent Bubble Reactor and its CFD Simulation

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

A Novel Passive Micromixer with Modified Asymmetric Lateral Wall Structures

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Liquid Backmixing and Particle Distribution in A Novel Multistage Internal-Loop Airlift Slurry Reactor

Mechanical stirring internal circulation resin ion exchange and adsorption reactor

Computational Fluid Dynamics Simulation and Experimental Study on Mixing Performance of a Three-Dimensional Circular Cyclone-Type Microreactor

Mixing Intensification in a Horizontal Self-Cleaning Twin-Shaft Kneader with a Highly Viscous Newtonian Fluid

Fast liquid mixing by cross-flow impingement in millimeter channels

Millisecond mixing of liquids using a novel jet nozzle

OPERATION AND SIMULATION OF COUPLED LIQUID-SOLID CIRCULATED MOVING BED REACTOR

Research Progress of Liquid-Liquid Fast Mixing Equipment

Backmixing characterization of liquid phase in ebullated bed reactor

The Characteristics of Liquid-Phase Methanol Synthesis in an Impinging Stream Reactor

Fast Liquid Jet Mixing in Millimeter Channels with Various Multislits Designs

Liquid-liquid flow pattern and mass transfer in a rotating millimeter channel reactor

Gas Holdup and Liquid Circulation Velocity in Gas-Liquid Two Stage Internal Loop Airlift Reactor

Solid-liquid mixing performance in a stirred tank with a double punched rigid-flexible impeller coupled with a chaotic motor

Investigation of hydrodynamics and mass transfer in an internal loop airlift slurry reactor integrating mixing and separation

Experimental Approaches for Understanding Mixing Performance of A Minireactor