Abstract:On the basis of alloy 800 H and alloy AC-66, materials introduced in the 1960s and the late 1980s, respectively, two new alloys, Cronifer III-TM (alloy III-TM) and Nicrofer 45-TM (alloy 45-TM), were developed to resist high sulfur and carbon-bearing environments. Carburization behaviour was examined in the temperature range 750–1100°C for more than 1000 h in CH4/H2 (ac = 0.8). The silicon-containing alloys Cronifer III-TM and Nicrofer 45-TM showed a mass gain similar to or even lower than that of the nickel-base alloy 625. Data on sulfidation resistance up to 650°C obtained in 10% SO2/N2 indicated a mass loss of less than 5gm−2 after 1000h for all alloys tested (800 H, AC-66, 625, III-TM, 45-TM). At 750°C alloy 800 H suffered breakaway corrosion and alloy 625 severe spallation. Alloys AC-66, III-TM and 45-TM showed superior corrosion resistance. Tests performed in a simulated coal gasification environment (1% H2S, 4% CO, 3% H20, balance H2) showed negligible mass gain for the alloys at 550°C. Results at 650°C remained satisfactory after 1000 h for alloys 800 H, AC-66, III-TM and 45-TM, with weight gains of less than 35 gm-2. Metallographic examination of the alloys, however, indicated local corrosion attack, which was lowest for 45-TM at 550°C and lowest for AC-66 at 650°C. Alloy 800 H showed the worst behaviour at all temperatures. Exposure tests in a simulated waste incineration atmosphere (2.5gm−3 HC1, 1.3g−3 SO2, 9% O2, balance N2) in the temperature range 550–850°C showed alloy 45-TM to have the best performance over the whole temperature range.

The Corrosion Behavior of Co-Cr-Al Alloys Exposed to Mixed Oxygen-Sulfur Atmospheres at 900 °C

High Temperature Oxidation Behavior of Co-20Re-25Cr-2Si Alloy at Different Oxygen Pressures

Revealing the Effect of O2, SO2 and H2O in Supercritical CO2 on the Corrosion Behavior of 316L Steel at Elevated Temperature

Scaling Behavior of Four Co-20Ni-xCr-yAl (x = 8,15 Wt.%; Y = 3,5 Wt.%) Alloys Exposed to 1 Atm O2 at 1000 °C and 1100 °C

The Effect of Sulfur on the Carburization of Three Fe–19Ni–21Cr– X Al ( X = 0, 2, 6 At.%) Alloys at 900 °C in Oxygen-Contaminated CH 4 –H 2 –H 2 S Atmospheres

Corrosion Behaviour of Ni-based Alloys 230, 617, and 601 in CO2 Gas at 750 and 850°C

Corrosion of Fe-Ni-Cr Alloys with Various Aluminum Additions in a Carburizing-Oxidizing Atmosphere at 900 °C

Carburization of Three Fe-19Ni-21Cr-xAl (x = 0, 2, 6 At.%) Alloys at 900 °C in Oxygen-Contaminated CH4/H2 Atmospheres

Effect of Cyclic Reaction on Corrosion Behavior of Chromium-Containing Alloys in CO2 Gas at 650 °C

Revealing the Role of SO2 in the High-Temperature Corrosion Diffusion of Two Superalloys in CO2 Through Molecular Dynamics and Thermal Stability

The Effect of Sulphur on the Carburization of Three Fe-19Ni-13Cr Alloys with Various Al Additions at 900 °C in Oxygen-Contaminated CH4-H2-H2S Atmospheres

Iron oxide fluxing and precipitation in sulphate deposits during heat-resistant alloy corrosion in simulated combustion gas

Hot Corrosion Behavior of Co–Al–W Superalloys with Si Additions

Corrosion of Alloy Steels Containing 2% Chromium in CO2 Environments

Studies on Corrosion Behavior of a Single-Crystal Superalloy and Its Sputtered Nanocrystalline Coatings with Solid NaCl Deposit in O2 + 38 Vol.% H2O Environment at 700 °C

Corrosion behaviour of high silicon alloys in carbon-bearing and high sulfur atmospheres

Corrosion Behavior of Newly Designed Fe-Ni-Base Alloys in High-Temperature CO2 at 700 °C

Oxidation Behavior and Lifetime Prediction of Three Commercial Alloys Used in Power Plants at 550 °C in CO2 Environment

10000 Hours Thermal Aging Behavior and Supercritical CO2 Corrosion Performance of Candidate Cladding AFA Alloys for Novel Gas - Cooled Reactors

Corrosion Performance of Heat-Resisting Steels and Alloys in Supercritical Carbon Dioxide at 650 °C and 15 MPa

Characterization and Simulation Studies on the Corrosion Products of HR230 and 740 H Alloys in CO2 with 7% H2O Environment at 1000 ℃