Abstract:Following the large‐scale integration of distributed power sources into distribution networks, fault currents undergo noticeable changes, which impacts the accuracy of conventional single‐phase ground fault algorithms. To tackle these issues, this work initially proposes an active distribution network ground fault protection algorithm based on the direction of extreme energy. Then, by establishing the electrical system structure and model of distribution network ground faults in the presence of distributed power sources, theoretical derivations and computations of transient zero‐sequence current frequency variations during fault instances are carried out. The characteristics of zero‐sequence current directions under distributed power sources integration are analysed, facilitating the design of a local ground fault determination algorithm grounded in the principle of energy extremum direction. This includes outlining fault determination and isolation procedures for ground fault monitoring equipment. Finally, through simulation testing, it is proven that the algorithm can reliably detect ground faults under both neutral point grounding configurations involving an arc suppression coil and ungrounded systems, across a range of transition resistances, varying numbers and capacities of distributed power sources connected, and differing grounding switch operation angles. After large‐scale distributed power sources are connected to the distribution network, the fault current undergoes noticeable changes, affecting the accuracy of traditional single‐phase grounding fault algorithms. Therefore, the objective of this paper is to address the impact of distributed power integration on the grounding algorithms of distribution networks. The main contribution is: by establishing an electrical system structure and model for distribution network grounding faults that include distributed generation (DG), theoretically deriving and calculating the transient zero‐sequence current frequency changes at the moment of fault, analysing the directional characteristics of zero‐sequence currents under DG connection conditions, designing a local grounding fault judgment algorithm based on energy extremum direction, and providing a fault judgment and isolation process for grounding fault monitoring devices. The results show: through simulation and experimentation, the algorithm was tested, and the method can reliably judge grounding faults under various transition resistances, different numbers and capacities of connected distributed power sources, and different grounding switch‐on angles. The applicability of the algorithm covers both methods of neutral grounding through an arc suppression coil and ungrounded neutrals, adapting to scenarios with or without DG connections.

Single-phase Grounding Fault Line Selection Method Based on the Difference of Electric Energy Information Between the Distribution End and the Load End

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Single‐pole Fault Line Selection Method for MVDC Distribution Grid Based on 0‐mode Power

Research on single-phase grounding fault location of distribution network with DG

Fault Location Method for Distribution Network Based on Synchronous Measurement

Research on Assisted Strategy of Fault Line Selecting Method for Single-phase Ground Fault in Distribution Netword Base on Automation System

Fault Line Selection Method of DC Distribution Network Based on Transient Current Fault Component

Single Line-to-ground Fault Location and Information Modeling Based on the Interaction between Intelligent Distribution Equipment

Grounding fault test technology of distribution network based on zero sequence power direction judgment

Regionalized Fault Line in Distribution Networks Based on an Improved SSA-VMD and Multi-Scale Fuzzy Entropy

Ground fault protection algorithm of active distribution network based on energy extremum direction

A Method of Single Phase to Ground Fault Feeder Selection Based on Single Phase Current Traveling Wave for Distribution Lines

Identification Method for High－resistance Sing Ie－phase Line Break in D istribution Networks Based on D istributed Measure ment

Identification Method for Single-line-to-ground Faults with Line Break Based on Phasor Measurement in Distribution Networks

A Novel Faulty Phase Selection Method for Single-Phase-to-Ground Fault in Distribution System Based on Transient Current Similarity Measurement

Typical Fault Characteristics Analysis of Distribution Network

A data-driven method to detect and localize the single-phase grounding fault in distribution network based on synchronized phasor measurement

The Impact of Cross Line Different-Phase Successive Faults on Fault Detection Devices

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics

A Self-healing Solution of Single-phase Ground Fault for Distribution Network without Communication