Abstract:Since the interconnect resources in FPGA cost more than 70% of the chip area, signal delay and power, it plays a crucial role in the implementation of high performance and lower power FPGA to improve performance and reduce power of the interconnect resources. The area, speed and power of the circuit are mutually constrained. Hence, how to design interconnect circuits with better performance and lower power has been a challenge in FPGA design.On the circuit-level design for FPGA interconnect circuits, this paper proposes topology selection strategy and Multi-V, strategy. The experimental results in 28nm process show that the Decode structure has an optimal DAP (Delay-Power product) when the size of MUX is less than 16, while the 2-level structure has an optimal DAP when the size of MUX is bigger than 16,ancl pass transistors and NMOS in the first stage of the subsequent buffer are replaced by the ultra-low V, transistor (ULVT) and low-V1 transistor (LVT) respectively can reduce the PDP(Power-Delay product) of interconnect circuits by 66.6%. Finally, these two strategies are used to optimize 8 types of interconnect circuits, and simulation results show that all the optimization rates of ADP (Area-Delay-Power product) are over 60%.

A programmable I/O buffer supported multiple differential standard based on 28nm technology

Design of High-Speed Data Buffer Based on FPGA for Gigabit-Rate Exchange Devices

A novel input/output interface circuit with high voltage tolerant and PCI compliant capabilities

A Dual Power Bus Transceiver with Multi-Voltage

A power efficient current-mode differential driver for FPGAs

Improving Source-Follower Buffer For High-Speed Adc Testing

Structure design of data buffer for high-speed exchange devices

Low-Voltage High-Linearity Differential Input Buffer with CurrentAmplifier Feed-Forward Compensation for High-Speed ADCs

A Capacitive Boosted Buffer Technique for High-Speed Process-Variation-tolerant Interconnect in UDVS Application

Low-voltage and High-Speed FPGA I/O Cell Design in 90nm CMOS

A Wideband High-linearity Input Buffer Based on Cascade Complementary Source Follower

Design of Data Buffer Circuit in High-speed, High-resolution Video Image Acquisition System on FPGA.

A New Design of Mixed-Voltage I/O Buffers with Low-Voltage-thin-oxide CMOS Process

A 1.8 Pj/Bit 16 X 16 Gb/S Source-Synchronous Parallel Interface in 32 Nm Soi Cmos with Receiver Redundancy for Link Recalibration

A Low Power, wide-band input buffer for 12bit 1GS/s ADC

A Delay-Optimized Universal FPGA Routing Architecture

Novel Mixed-Voltage I/O Buffer with Thin-Oxide Cmos Transistors

Design and Implementation of a Delay-Optimized Universal Programmable Routing Circuit for FPGAs

A Wideband Input Buffer Based on Cascade Complementary Source Follower

Research On Circuit-Level Design Of High Performance And Low Power Fpga Interconnect Circuits In 28nm Process

A 6-Ghz Bandwidth Input Buffer Based on AC-Coupled Flipped Source Follower for 12-Bit 8-Gs/s ADC in 28-Nm CMOS