Abstract:Since the interconnect resources in FPGA cost more than 70% of the chip area, signal delay and power, it plays a crucial role in the implementation of high performance and lower power FPGA to improve performance and reduce power of the interconnect resources. The area, speed and power of the circuit are mutually constrained. Hence, how to design interconnect circuits with better performance and lower power has been a challenge in FPGA design.On the circuit-level design for FPGA interconnect circuits, this paper proposes topology selection strategy and Multi-V, strategy. The experimental results in 28nm process show that the Decode structure has an optimal DAP (Delay-Power product) when the size of MUX is less than 16, while the 2-level structure has an optimal DAP when the size of MUX is bigger than 16,ancl pass transistors and NMOS in the first stage of the subsequent buffer are replaced by the ultra-low V, transistor (ULVT) and low-V1 transistor (LVT) respectively can reduce the PDP(Power-Delay product) of interconnect circuits by 66.6%. Finally, these two strategies are used to optimize 8 types of interconnect circuits, and simulation results show that all the optimization rates of ADP (Area-Delay-Power product) are over 60%.

A Dual Power Bus Transceiver with Multi-Voltage

A Five-Level Converter Interfacing Medium-Voltage

Fully Integrated High-Voltage Level Shifts and Drivers for Buck Converters.

Design of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter for Modern FPGAs at 10Mhz

Design and Implementation of FPGA Based High-Speed Bus for Control System

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Reconfigurable Memory Bus Systems Using Multi-Gbps/pin CDMA I/O Transceivers.

A programmable I/O buffer supported multiple differential standard based on 28nm technology

A novel input/output interface circuit with high voltage tolerant and PCI compliant capabilities

Design and Implementation of High-Speed Data Transmission Scheme Between FPGA Boards Based on Virtex ‐7 Series

A Mixed Voltage Bidirectional I/O IP Corewith Low Power Modification for Automotive BCM SoC

Design and experiment of modular multilevel converter prototype with 49-level output voltages

Application of FPGA in High-Power Multiphase Variable Speed Drives

Design of Multi-serial Communication for Flight Controlling Computer Based on FPGA

A Sub-100mV Ultra-Low Voltage Level-Shifter Using Current Limiting Cross-Coupled Technique for Wide-Range Conversion to I/O Voltage

Dual- Channel High- Speed Data Transmission System of Industrial CT

High speed serial interface transceiver controller based on JESD204B

Design of Data Transmission System Based on FPGA and USB 2.0

Research On Circuit-Level Design Of High Performance And Low Power Fpga Interconnect Circuits In 28nm Process

Expandable Single-FPGA-Based DVI Transmitter

Low Power Design of Multi-mode Switching Power Supply Controller IC