Abstract:With the increasing performance requirements of network data interaction on chip, the traditional Direct Memory Access (DMA) often performs with low efficiency of multi-module collaboration due to the competition of bus control, thereby reducing the throughput rate of the bus. Aiming at the working characteristics of inter-core communication and data interaction between multiple modules, this paper designs a packet transmission module Bi-Transfer that supports bidirectional data flow between multiple modules It also realizes chaining transmission of input and output data in parallel with various configuration modes and flexible data scheduling modes. This module can complete the functions of data movement, inter-core communication, task management, etc., and use descriptors to link load data packets to uniformly conFigure the data interaction mode of the on-chip network. In the experimental stage, function planning and code design are carried out first, then the timing simulation and data recording are described. Finally, the performance characteristics of this new data interaction module are discussed. According to statistical observations, increasing the number of channels in the design module can significantly increase the bandwidth of the bus. Under the given clock frequency, bus width and data transmission requirements, the bus operating bandwidth in the four-channel working mode can reach up to 4690 MB/s at most, which is nearly 400 MB/s beyond the ordinary DMA bus bandwidth. In the case of fewer channels, this module can fulfill the data scheduling requirements of most applications and provide the data moving function of ordinary DMA.

Reconfigurable Memory Bus Systems Using Multi-Gbps/pin CDMA I/O Transceivers.

Reconfigurable Memory Bus Systems Using Multi-Gbps/Pin Cdma 1/0 Transceivers

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

An RF/baseband FDMA-interconnect Transceiver for Reconfigurable Multiple Access Chip-to-chip Communication

The Design of Intelligent 429 Bus Interface Card Based on Dual-Port RAM

A 1.8 Pj/Bit 16 X 16 Gb/S Source-Synchronous Parallel Interface in 32 Nm Soi Cmos with Receiver Redundancy for Link Recalibration

Physical Design of 2 133 Mb/s DDR3 Memory Interface

Design and implementation of parallel multi-access memory interface

Configurable Multi-Port Memory Architecture for High-Speed Data Communication

Bit-Interleaved Optical Bus for High-Speed Secure Multi-Board System

Design of High Speed Data Transmission System Based on CPCI Bus and LVDS

A 4x32Gb/s 1.8pJ/bit Collaborative Baud-Rate CDR with Background Eye-Climbing Algorithm and Low-Power Global Clock Distribution

Implementation Of 40gbps Pcs In 0.18 Mu M Cmos Technology

A Fully-Synthesizable 10.06gbps 16.1mw Injection-Locked CDR in 28nm FDSOI.

Energy efficient 5 Gb/s baseband transceiver for 3D memory interconnect

A 5-10-gb/s 12.5-Mw Source Synchronous I/O Interface with 3-D Flip Chip Package

Bi-Transfer: A Data Packet Allocation Module with Chaining Transmission Mode

A Novel Design of High-speed Multi-port Memory Interface for Digital Signal Processor

Architecture design and performance analysis of a novel memory system for high-bandwidth onboard switching fabric

Generalized Coincident Pulse Technique and New Addressing Schemes for Time-Division Multiplexing Optical Buses

Design of the Reflective Memory Card Based on PCI Bus