Abstract:In this paper, a hybrid modular multilevel converter (MMC) topology with an improved nearest level modulation method is proposed for medium-voltage high-power applications. The arm of the proposed topology contains N series connected half-bridge submodules (HBSMs), one full-bridge submodule (FBSM) and an inductor. By exploiting the FBSM, half-level voltages are obtained in the arm voltages. Therefore, an output voltage with a 2N+1 level number can be generated. Moreover, the total level number of the inserted submodules (SMs) is a constant. Thus, there is no pulse voltage across the arm inductors, and the SM capacitor voltage is rated. With the proposed voltage balancing method, the capacitor voltage of the IABSM is twice the voltage of the FBSM, and each IGBT of the FBSM has a relatively low switching frequency and an equalized conduction loss. The capacitor voltage balancing methods of the two kinds of SMs are implemented independently. As a result, the switching frequency of the HBSM is not increased compared to the conventional MMC. In addition, according to a theoretical calculation of the total harmonic distortion of the electromotive force (EMF), the voltage quality with the presented method can be significantly enhanced when the SM number is relatively small. Simulation and experimental results obtained with a MMC-based inverter verify the validity of the developed method.

A Mixed Voltage Bidirectional I/O IP Corewith Low Power Modification for Automotive BCM SoC

Fully Integrated High-Voltage Level Shifts and Drivers for Buck Converters.

A Dual Power Bus Transceiver with Multi-Voltage

High-precision voltage measurement IP core for battery management SoC of electric vehicles

A Winding Multiplexing Method for Single-Phase and Three-Phase On-Board Integrated Battery Chargers Based on Multiphase Motor

A Smooth Mode-Switching Strategy for Bidirectional OBC Base on V2G Technology

A simple method for configuring multi-PWM channels for multi-level converter applications based on PWM IP core

A Low Power MCU Design for Battery-Less TPMS SoC

A New Design of Mixed-Voltage I/O Buffers with Low-Voltage-thin-oxide CMOS Process

A Hybrid Modular Multilevel Converter Topology with an Improved Nearest Level Modulation Method

The Design and Implementation of PC/104-Compatible Interface and Traffic Store Hardware in a Class 4MVB Controller

Performance-Aware Power Management in Embedded Controllers with Multiple-Voltage Processors

A Sub-100mV Ultra-Low Voltage Level-Shifter Using Current Limiting Cross-Coupled Technique for Wide-Range Conversion to I/O Voltage

Low Power-Consumption IP Core Design on for Universal Video Output Controller

Mixed-Signal Soc Design and Low Power Research for Tire Pressure Monitoring Systems

A low-power power management circuit for SoC in Tire Pressure Monitoring System

A 0.18 μ m high-voltage area efficient integrated gate driver for piston engine fuel injection control SoC

High Efficiency Wide Range Bidirectional DC/DC Converter for OBCM Application

Design of a Monolithic Hot Swap Controller IC with BCD Technology

Novel Mixed-Voltage I/O Buffer with Thin-Oxide Cmos Transistors

A High-Voltage High-PSRR Power Management Circuit for BMS Chip of New Energy Vehicle