Abstract:The hybrid process of selective noncatalytic reduction (SNCR) followed by selective catalytic reduction (SCR) is an up-to-date nitrogen oxides control technique and can achieve a high efficiency (60%-95%) with moderate cost. The SNCR/SCR hybridization was investigated through experimentation on a 100MW, coal-fired utility boiler in China. The baseline nitrogen oxides emission of the hybrid urea-based SNCR/SCR system was 170 ppm at 6% O(2) controlled by coal reburning technology. The hybrid SNCR/SCR system including only 89 m(3) catalysts could control NO emission under 25 ppm with ammonia slip <4ppm at 300-430 tons/h of boiler load. Total NO reduction efficiency was generally about 85% and could be beyond 90%, in which SCR's efficiency was 50%-70% individually and SNCRs was about 60%-75%. NO emission decreased from about 65 to 15 ppm when the flow rate of 35% urea solution increased from 0.15 to 0.47 tons/h. At higher boiler load, more urea solution had to be injected and higher layer of the agent injectors had to come into operation to hit the same emission target. The superheated steam was injected with high speed into flue gases at the inlet of reversing chamber and it was effective on enhancing both the total quantities and the distribution of SNCR's ammonia residue, which was used as reducing agent of SCR. In general there was more NH(3) where there was less NO at the inlet of catalysts and NO distribution was contrary to NH(3) distribution in some way. NO and NH(3) distribution at the outlet of catalysts was almost even compared with the inlet distribution. Average NH(3) slip at the outlet increased with NH(3) at the inlet and could be controlled below 4 ppm at 6% O(2) in any case. The difference between average NH(3) at the inlet and the outlet was smaller several times than the reduced NO by SCR catalysts. Some isocyanic acid (HNCO) as the product of urea solution thermohydrolysis might exist in the flue gas and it was hydrolyzed to NH(3) quickly on SCR catalysts, which then reduced NO on the surface of SCR catalysts.

Numerical simulation and engineering confirmation of hybird SNCR/SCR process in commercial coal-fired boiler

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Numerical Study of SNCR Process in Large Coal Fired Utility Boiler

Numerical Simulation on Optimization of SCR Denitrification System for Coal-fired Boilers

Numerical Study of SNCR Process in Coal-Fired Boiler with Large Capacity

Numerical Study of Selective Non-Catalytic Reduction Process in Large Utility Boiler

Full-Scale Numerical Investigation of a Selective Noncatalytic Reduction (SNCR) System in a 100 MW Utility Boiler with Complex Chemistry and Decoupling Approach

Application of Hybrid Coal Reburning/SNCR Processes for NOx Reduction in a Coal-Fired Boiler

Numerical Simulation of Furnace Process in a 600 MW Ultra Supercritical Boiler Utilizing Selective Noncatalytic Reduction Technology

Numerical Simulation and Optimization of SNCR System for CFB Boilers

Optimal design of a SCR-DeNOx system for a 300MW coal-fired power plant

Coordinated Optimization Control of Flue Gas Temperature for Improving Reaction Efficiency of Catalyst

Numerical study of mixing characteristic between flue and droplet at 410t/h coal-fired boiler SNCR system

Cost-Efficient Nitrogen Oxides Control by a Hybrid Selective Noncatalytic Reduction and Selective Catalytic Reduction System on a Utility Boiler

Denitration Simulation of SNCR System Nozzles at Different Layout Positions in Coal Powder Boilers

Industrial Trials of High-temperature SNCR Injected in Primary Combustion Zone in a 50mwe Tangentially Firing Pulverized-Coal Boiler for Deeper NOx Reduction

Low NOx combustion and SCR flow field optimization in a low volatile coal fired boiler

Application of Selective Non-catalytic Reduction on a Power Plant Boiler

Investigating the Optimization Design of Internal Flow Fields Using a Selective Catalytic Reduction Device and Computational Fluid Dynamics

Industrial Trials Of High-Temperature Selective Noncatalytic Reduction Injected In The Primary Combustion Zone In A 50 Mwe Tangentially Firing Pulverized-Coal Boiler For Deeper Nox Reduction

Application of CFD in the optimal design of a SCR–DeNOx system for a 300 MW coal-fired power plant