Abstract:In the last few years, broadband and switchable frequency selective surfaces (FSSs) absorber/reflector are of great importance in different areas such as stealth system, EM interference, EM compatibility, and so on. In this paper, to obtain a switchable frequency selective surfaces absorber/reflector in different states, a broadband and switchable absorber using an absorb/reflective FSS is presented. The top layer of the proposed switchable absorber is a periodic arrangement of square loops loaded with PIN diodes on a dielectric substrate which has a sufficient mechanical strength to hold up all the units, and under the square loops there are honeycomb of a certain thickness and a thin layer of metal. The structure has been characterized with the full-wave analysis and shows good absorption/reflection switching performance. Intrinsic impedance of proposed structure has also been investigated to explain the switching and the broadband absorption mechanisms of the structure. The working frequency band of the switchable absorbing structure is 2.5 ~ 5.5 GHz, and it switches states by changing the bias voltage. Biasing at different voltages to turn ON and OFF the diodes, the FSS structure can switch freely between absorption and reflection state. In ON state, the switchable FSS has two states working as a wideband absorber and the reflectivity in 2.5 ~ 5.5 GHz is below -10 dB, while in OFF state it has fine reflective property. In addition, inductances are used to connect each element of the structure to achieve the purpose of broadband isolation. Simulation and measurement results demonstrate the performance of the proposed structure.

Embedding Absorptive Single-Pole-Eight-Throw Switch

Non‐Hermitian Loss‐driven Broadband Low‐Loss On‐chip Terahertz Photonic SPDT Switch

Switchable Rasorber/Absorber Based on PIN Diodes

A Low-Supply-voltage High-Power-handling Stacked SPDT Switch Based on Feedforward Capacitors.

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

Ultra-wideband amplitude-phase compensation digital switch attenuator circuit

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

High-speed 8&#x00d7;8 Electro-Optic Switch Matrix Based on Silicon PIN Structure Waveguides

Switchable Reflective Point Design for Ultrabroadband Microwave Absorber

A broadband low‐loss SPDT RF switch using a new off‐chip compensation technology

1 x N (N=2, 8) Silicon Selector Switch for Prospective Technologies at the 2 m Waveband

Low-insertion loss pin diode switches using impedance-transformation networks

A Sub-6G SP32T Single-Chip Switch with Nanosecond Switching Speed for 5G Applications in 0.25 Μm GaAs Technology

A Single-Pole Double-Throw (SPDT) Circuit Using Lateral Metal-Contact Micromachined Switches

Four-Mode Switchable Frequency-Selective Surface Featuring Wide-Band and Angular Stability

The Design of a 57-65Ghz SPDT Switch with LC Resonant Techniques in 40 Nm CMOS Process

A CMOS SPDT RF Switch with 68 Db Isolation and 1.0 Db Loss Feathering Switched Resonance Network for MIMO Applications

Switchable Electromagnetic Absorber/Reflectors Using Back-Loaded Active Radio Frequency Circuits

Non-blocking 8×8 Silicon Electro-Optic Switch

Parasitic Effect Suppression with Resonance Cancelation for Broadband Absorber/Reflector

1.866–2.782-GHz Reconfigurable Filtering Single-Pole-Multithrow Switches Based on Evanescent-Mode Cavity Resonators