Abstract:Background, aims and scope: Hexavalent chromium [Cr(VI)] cannot react with either carbonate or hydroxide to form chromium precipitates. However, by using a precipitation technology to treat plating wastewater containing Cr(VI), Cu(II), Ni(II) and Zn(II), approximately 78% of Cr(VI) (initial 60 mg/L) was co-removed with the precipitation of Cu(II), Ni(II) and Zn(II) (each 150 mg/L) by dosing with Na2CO3 (Sun 2003). Direct precipitation by forming Cu(II)-Cr(VI) precipitates followed by adsorption of Cr(VI) onto freshly formed Cu-precipitates was subsequently found to be the main mechanism(s) involved in Cr(VI) co-removal with Cu(II) precipitation by dosing Na2CO3 stepwise to various pH values (Sun et al. 2003). This study was. carried out to further characterize the formation of primary precipitates during the early stages of copper precipitation and simultaneous removal of Cr(VI) with Cu(II). Methods: Test metal-solutions were prepared with industrial grade chemicals: CuCl2 x 2H2O, Na2SO4 and K2Cr2207. NaCO3 was added drop-wise to synthetic metal-solution to progressively increase pH. For each pH increment, removal of soluble metals was detected by atomic absorption spectrophotometer (AAS) and surface morphology of precipitates was analyzed by scanning electron microscope (SEM). To further characterize the formation of primary precipitates, a series of MINEQL+ thermodynamic calculations/analyses and equilibrium calculations/ analyses were conducted. Results and discussion: MINEQL+ thermodynamic calculation indicated that, for a system containing 150 mg/L Cu(II) and 60 mg/L Cr(VI) with gradual Na2CO3 dosing, if any precipitates can be formed at pH 5.0 or lower, it should be in the form of CuCrO4. Comparison tests using systems containing the same equivalent of Cu(II) plus Cr(VI) and Cu(II) plus SO4(2-) showed that the precipitation occurred at a pH of around 5.0 in the Cu(II)-Cr(VI) system and around 6.0 in the Cu(II)-SO4(2-) system. The discrepancy of the precipitation was indeed caused by the formation of Cu-Cr precipitates. The initiation of copper removal at pH around 5.0 for the Cu-Cr co-removal test was not attributable to the formation of Cu-CO3 precipitates, instead, it was most likely through the formation of insoluble Cu-Cr precipitates, such as CuCrO4 and CuCrO4 x 2Cu(OH)2. Experimental tests, equilibrium calculations, MINEQL+ thermodynamic calculations and surface morphologies for systems using higher concentrations of Cu(II) and Cr(VI) further verified the most probable composition of primary precipitates is copper-chromate. Conclusion: In the Cu-Cr co-removal test with Na2O3 dosing to increase pH and induce metal precipitation, copper-chromate precipitates are the primary precipitates produced and contribute to the initial simultaneous removal of copper and chromium.

Thermodynamic analysis on removal of copper selectively from cobalt chloride solution

REMOVAL OF AQUEOUS Cu(II) WITH NATURAL KAOLIN: KINETICS AND EQUILIBRIUM STUDIES

High Efficient Removal of Cu(II) by a Chelating Resin from Strong Acidic Solutions: Complex Formation and DFT Certification

Cobalt Sulfide Derived from Metal Organic Framework for Selective Treatment of Low Concentration Copper Wastewater: Catalytic Ability, Reaction Efficacy, and Mechanism

Adsorption Performances for Aqueous Cu(II) onto Chelating Resin Dowex M-4195: Interaction Mechanism Investigation

Removal Of Copper(Ii) From An Aqueous Solution With Copper(Ii)-Imprinted Chitosan Microspheres

Characterization of primary precipitate composition formed during co-removal of Cr(VI) with Cu(II) in synthetic wastewater

An Insight into Properties and Mechanisms of a Dithiocarbamate Chelating Agent for the Removal of Toxic Metal Ions from Metallic Mine Wastewater

THERMODYNAMICS OF SOLVENT EXTRACTION OF METALS (VII) EHEHPA-CoSO4-CuSO4 System

Optimization Study of Operation Parameters for Extracting \hbox {Cu}^{2+} from Sulfuric Solution Containing \hbox {Co}^{2+} with LIX984N in a Laminar Microchip

The influence of Cl- on the electrochemical dissolution of cobalt white alloy containing high silicon in a sulfuric acid solution

Application of the Taguchi Method and Central Composite Design for the Highly Selective and Efficient Extraction of Cu(II) ions from an Aqueous Solution Containing Mn(II), Co(II), Ni(II), Zn(II), Cu(II), and Pb(II) ions Mixture Using Benzyl Bis(thiosemicarbazone)

Selective Removal of Transient Metal Ions from Acid Mine Drainage and the Possibility of Metallic Copper Recovery with Electrolysis

Diverse Surface Chemistry of Cobalt Ferrite Nanoparticles to Optimize Copper(II) Removal from Aqueous Media

Solvent extraction-based recovery of Co from leach solutions of Cu Co ores using a Mextral 6103H-naphthenic acid- isooctanol system

Removal of Copper(Ii) Ions from Aqueous Solutions Using Natural Kaolinite

Purification of chlorine-containing copper smelting wastewater using extraction-stripping-salting out method

Extraction Floatation Method for Separation of Copper(II) with Ascorbic Acid Ammonium Thiocyanate Ethanol System in Presence of Ammonium Sulphate

Optimization Study of Operation Parameters for Extracting Cu^2+ from Sulfuric Solution Containing Co^2+ with LIX984N in a Laminar Microchip

Removal of Copper and Lead from Aqueous Solution by Adsorption Onto Cross-Linked Chitosan/Montmorillonite Nanocomposites in the Presence of Hydroxyl–Aluminum Oligomeric Cations: Equilibrium, Kinetic, and Thermodynamic Studies

THERMODYNAMICS OF SOLVENT EXTRACTION OF METALS(V) EHEHPA-CoSO4 System