Abstract:Ultrahigh‐speed casting is the most remarkable feature of billet high‐efficiency continuous casting. The transient fluid flow, heat transfer, and solidification behavior under different casting speeds, submerged entry nozzle (SEN) parameters, and mold electromagnetic stirring (M‐EMS) are investigated using a 3D transient mathematical model. The results show that a typical roll flow pattern is generated for all casting speeds, while a third small recirculation zone developed near the solidified shell at the casting speed of 6.0 m min−1. When the casting speed increases, the impact depth of the molten steel increases from 0.748 to 0.844 m, the velocity and level fluctuation at the steel/slag interface increases, the high‐temperature zone moves downward, and the shell thickness is reduced from 16.2 to 11.1 mm. As the SEN inner diameter and immersion depth increases, the impact depth increases, the velocity and level fluctuation at the steel/slag interface decreases, and the shell thickness at the mold exit is ≈11.0 mm. When the SEN immersion depth and inner diameter are 120 and 40 mm, respectively, the flow and temperature fields in the mold are the most appropriate. In addition, the M‐EMS have a great effect on the fluid flow and heat transfer behavior. A coupled 3D numerical model is established to study the fluid flow, heat transfer, and solidification in a billet continuous casting mold under different casting speeds, submerged entry nozzle (SEN) inner diameters, SEN immersion depths, and mold electromagnetic stirring (M‐EMS). The velocity field, temperature field, steel/slag level fluctuation, and the growth of solidified shell are analyzed comparatively.

3-D Numerical Simulation of Molten Aluminum Flow in Feed Tip Nozzles of Twin Roll-Casting

Numerical Simulation of Molten Pool and Control Strategy of Kiss Point in a Twin-Roll Strip Casting Process

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

Numerical Simulation of the Flow Field in an Ultrahigh-Speed Continuous Casting Billet Mold

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

3D Numerical Simulation of Temperature Field Coupled with Flow Field of the Liquid Metal in Shot Sleeve of Die Casting Process

Coupled thermal-fluid-mechanics analysis of twin roll casting of A7075 aluminum alloy

Numerical Simulation of Temperature Field and Grain Structure in Cu-10Al Alloy Produced by Heated Mould Continuous Casting

Numerical Simulation on Compression Casting Process for Copper-Alloy Floor Drain

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

Numerical simulation of melt flow and temperature field during DC casting 2024 aluminium alloy under different casting conditions

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Numerical Simulation on Fluid Flow, Heat and Mass Transfer in Solidification of Fe-C Alloys

Three-dimensional FEM Study of Fluid Flow in Mould for Beam Blank Continuous Casting: Influence of Nozzle Structure and Parameters on Fluid Flow

Numerical Simulation of the Fluid Flow, Heat Transfer, and Solidification in Ultrahigh Speed Continuous Casting Billet Mold

Numerical simulation of fluid flow and free surface fluctuations during wheel and belt casting process

Simulation of microstructures in solidification of aluminum twin-roll casting based on CA

Physical and Numerical Simulation Study on Structure Optimization of the Inner Wall of Submerged Entry Nozzle for Continuous Casting of Molten Steel

Mould Taper Optimization for Continuous Casting Steels by Numerical Simulation

Fluid Flow in Continuous Casting Mold with a Configured Nozzle