Abstract:The microstructures and mechanical properties of Al-Si-Mg-Cu-Mn alloys that were squeeze-casted with varying La-Ce mixed rare earth content were analyzed by testing tensile strength and hardness and examining microstructures using various methods such as the optical microscopy, scanning electron microscopy, energy dispersive spectrum spectroscopy, and image analysis. The experimental results revealed that the elongation was affected by the iron content and the Chinese script iron phase showed less damage to the elongation compared to other blocky iron phases. The rare earth element Ce reacts with Al 2 O 3 to form Ce 2 O 3 , which can act as a heterogeneous nucleating agent for α-Fe. This is because of the two-dimensional lattice mismatch between the and , which is specifically 4.5%, which is less than 12%. As the amount of α-Fe increases, the Fe content around the growth of the iron phase decreases. Meanwhile, the rare earth adsorbed on the iron phase would inhibit preferential growth and promote isotropic growth. With an increase in mixed rare earth content, the Chinese script iron phase would transform into a round and fine blocky shape. As a result, the fracture mode shifted from a combination of ductile and brittle fracture to a brittle fracture, accompanied by a transition from transgranular cleavage to transgranular–intergranular cleavage. At a mixed rare earth content of 0.07%, the material exhibited the best comprehensive properties after heat treatment, with a tensile strength of 371.7 MPa, yield strength of 285.7 MPa, and elongation of 4.2%. When the rare earth addition was 0.37%, the hardness of 6066 aluminum alloy reached the maximum value of 123.5 HBW.

Investigation of Properties of Hot-dipped Ce-rich Rare Earth Aluminum Alloy upon Conditions of Corrosion Environment

EFFECT OF CERIUM AND LANTHANUM ALLOYING ON MICROSTRUCTURE AND CORROSION BEHAVIOR OF AZ91 MAGNESIUM ALLOY

Influence of mixed rare earth elements(Y and Ce) on the microstructure and corrosion behaviour of Mg-4Al-3Ca alloy

Effects of Rare Earth Additions on Compound Structure and As-Annealed Properties of Cu-12%Ag

Influence of Cr on Microstructure and Electrochemical Properties of FeNiMnCuCrx High-entropy Alloy

Effect of Ce on structural evolution and corrosion resistance of HRB500E rebar corrosion layer

Effects of rare earth Er additions on microstructure development and mechanical properties of die-cast ADC12 aluminum alloy

Effect of Mixed Rare Earth on the Iron Phase and Tensile Properties in Squeeze Casting 6066 Aluminum Alloys

Effect of Ce on the localized corrosion behavior of non-equiatomic high-entropy alloy Fe40Mn20Cr20Ni20 in 0.5 M H2SO4 solution

Effect of rare earth Ce and Y on microstructure and viscosity of ZL114A alloy

Effect of Rare Earth Element Ce and La on Corrosion Behavior of AM60 Magnesium Alloy

The Effects of Ce on Hot Corrosion of Iron-based Alloys

Study on Influence of Rare Earth Ce on Micro and Macro Properties of U75V Steel

Tailoring the microstructure and enhancing the corrosion resistance of extruded dilute Mg-0.6Al-0.5Mn-0.25Ca alloy by adding trace Ce

The Influence of Rare Earth Elements on Microstructures and Properties of 6061 Aluminum Alloy Vacuum-Brazed Joints

Effect of cerium on the microstructure and anti-corrosion performance of Al-Zn coatings

Effect of rare earth cerium on the microstructure and corrosion resistance of laser cladded nickel-base alloy coatings

Effect of Ce on Hot Tearing Sensitivity of As-Cast Al-Cu-Mg-Y Alloy

Effect of rare earth content on microstructure and corrosion resistance of hot-dip Zn–5Al alloy coated steel wire for bridge cables

Effect of rare earth La–Ce on solidification structure of 3.2%Si-0.9%Al non-oriented silicon steel

Effect of Rare Earth on Micro-Arc Oxidation of Mg Alloy