Abstract:In a steam turbine system, one of the main factors limiting the operational flexibility is the thermal stress associated with a high-temperature gradient within the control valves, which often leads to structural damage during frequent startup and shutdown cycles. One possible solution is to utilize an electric heating system with appropriate insulation to decrease the warm-up time. Here, an experiment and a numerical simulation were performed using a scaled turbine valve equipped with an electric heating system to understand the heat transfer process. The experiment, which was conducted at Shanghai Jiao Tong University, had a duration of 100 h and included three heating-cooling cycles and two heat preservation states. The results showed that the temperature distribution of the scaled valve was uniform, which is due to the high thermal conductivity of the valve body and the low conductivity of the insulation layer. The simulation, which used the commercial software ansys fluent 2019 R1, was performed to model the experimental heat transfer process and showed less than 10% deviation from the measured temperatures. A sensitivity study revealed that the valve temperature is very insensitive to the heat transfer coefficient of the outer surface of the insulation layer, which is attributed to the negative feedback regulation of radiation heat transfer. To further improve the computing efficiency, a simplified model based on the lumped parameter method and the quasi-steady-state assumption was proposed and validated. This model can predict the 100 h valve temperature history in less than 1 min and showed good agreement for all of the studied cases. The ability of the simplified model to simulate the valve heating-cooling cycles at a high efficiency could accelerate the thermal design process to improve the operational flexibility of steam turbines in the future.

Influence of Thermal Interface Materials on Thermal Resistance of Thyristor Valve

Research on Reliability Assessment of Thyristor in HVDC Converter Valve

Influence Of Hvdc Thyristor Junction Temperature On Voltage Characteristics

A Comprehensive Heat Transfer Study Inside a Steam Turbine Valve: Experiment, Numerical Simulation, and Simplified Model

Effects of temperature and pressure on interfacial thermal resistance of thermal interface materials in coupled heat transfer process with vapor chamber

Tesla valves and capillary structures-activated thermal regulator

Thermo-mechanical Stress Analysis of Feed-Water Valves in Nuclear Power Plants

Research on Fluid Dynamics and Thermal Characteristics in Hydraulic Valves by Thermal-Fluid-Solid Coupling Method

High Current Temperature-Rise Test and Simulation Calculation of Valve Hall Fittings

Effectiveness of Thermal Interface Materials on Electrical Machines Thermal Performance with Heat Pipes

Effect of High-Thermal Conductivity Epoxy Resin on Heat Dissipation Performance of Saturated Reactor

Water storage for HVDC thyristor valves cooling system topic 1–1.d. power system integration, packaging & thermal management. I

Study on the Contact Resistance and Temperature-rise Performance of High-voltage Vacuum Interrupter

Accelerated Life Test Study on Thyristors of HVDC Converter Valve

Influence of Temperature and Aging on the Thermal Contact Resistance in Thermoelectric Devices

Enhancement on Heat Transfer and Reliability of Low Melting Temperature Alloy Based Thermal Interface Materials

Design and Implementation of Synthetic Test System for Thyristor Level of HVDC Converter Valve

Energy-saving Effect of Using New Material in Reversing Valve

Valve Body’ s Thermal Characteristics Analysis for High-Temperature Electrical Gate Valves and Its Optimal Design

Thermal Simulation of High-Power DC Contactor and Analysis of Influencing Factors

Advanced Thermal Interface Materials for Thermal Management