Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Water storage for HVDC thyristor valves cooling system topic 1–1.d. power system integration, packaging & thermal management. I

Hybrid Cooling System for Hvdc Convertor Valves

Energy Saving Assessment Of Evaporative Cooling Hvdc Valves

The Application of Evaporative Cooling Technology in HDVC Converter Station

Anhydrous Cooling Mode Applied in External Cooling Equipment of HVDC Converter

Water Cooling System for Converter ofMW-Class Wind Power Generators Adaptable to Extreme High Temperature Environment

Experimental Investigation on Storage-Type Heat Pump System for Efficient Supply in Cold Region

A Theoretical Study of New-Style Cool Storage Air-Conditioning Systems with High-Temperature Water

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

The application and research of the full-closed circulating water-cooling system in SVCs

Heat Dissipation Improvement and Experimental Verification of Converter Transformer Valve Side Bushing Based on Water Cooling Technology

Performance Study of a Constant Temperature and Humidity Air-Conditioning System with Temperature and Humidity Independent Control Device

Design and Implementation of Synthetic Test System for Thyristor Level of HVDC Converter Valve

Performance Study of Phase Change Charging/discharging Processes of Condensing Heat Storage in Cold Regions Based on a Mathematical Model

Analysis of Potential Dangers Leading to HVDC Outage in Valve Cooling System

Influence of Thermal Interface Materials on Thermal Resistance of Thyristor Valve

THE DEVELOPMENT OF PURE WATER COOLING SYSTEM FOR HIGH POWER CONVERTER

Research on Reliability Assessment of Thyristor in HVDC Converter Valve

TECHNIQUE FEATURES OF THYRISTOR VALVE USED FOR ±500 kV HVDC TRANSMISSION FROM THE THREE GORGES TO CHANGZHOU

Remote cryogenic helium gas circulating cooling system for a 10-Mvar class HTS dynamic synchronous condenser

Chilled water storage air conditioning system with independent temperature-humidity control