Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

Hybrid Cooling System for Hvdc Convertor Valves

Water storage for HVDC thyristor valves cooling system topic 1–1.d. power system integration, packaging & thermal management. I

Energy Saving Assessment Of Evaporative Cooling Hvdc Valves

The Application of Evaporative Cooling Technology in HDVC Converter Station

Anhydrous Cooling Mode Applied in External Cooling Equipment of HVDC Converter

Cascaded H7 Current Source Converter Based Power Transmission System And Fault Analysis

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

The Development of HVDC Transmission System

Water Cooling System for Converter ofMW-Class Wind Power Generators Adaptable to Extreme High Temperature Environment

Heat Dissipation Improvement and Experimental Verification of Converter Transformer Valve Side Bushing Based on Water Cooling Technology

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Study on Hybrid HVDC Transmission Technology Used for Upgrading of Conventional HVDC Transmission System

DISCUSSION ON SEVERAL IMPORTANT PROBLEMS OF DEVELOPING UHV AC TRANSMISSON IN CHINA

Analysis on Insulation Coordination Scheme for ±800 Kv DC Converter Station

Grounding Methods of Multi-Terminal VSC-HVDC System Based on Modular Multi-level Converter

The application and research of the full-closed circulating water-cooling system in SVCs

Analysis of Potential Dangers Leading to HVDC Outage in Valve Cooling System

THE DEVELOPMENT OF PURE WATER COOLING SYSTEM FOR HIGH POWER CONVERTER

Comprehensive Comparison of Hybrid Cooling of Thermal Power Generation with Airside Serial and Parallel Heat Exchange

Evaluation of PLC Reforming Program of 800kV Fengxian Converter Station Valve Cooling System

Novel Hybrid DC/DC Converter Topology for HVDC Interconnections