Abstract:In a steam turbine system, one of the main factors limiting the operational flexibility is the thermal stress associated with a high-temperature gradient within the control valves, which often leads to structural damage during frequent startup and shutdown cycles. One possible solution is to utilize an electric heating system with appropriate insulation to decrease the warm-up time. Here, an experiment and a numerical simulation were performed using a scaled turbine valve equipped with an electric heating system to understand the heat transfer process. The experiment, which was conducted at Shanghai Jiao Tong University, had a duration of 100 h and included three heating-cooling cycles and two heat preservation states. The results showed that the temperature distribution of the scaled valve was uniform, which is due to the high thermal conductivity of the valve body and the low conductivity of the insulation layer. The simulation, which used the commercial software ansys fluent 2019 R1, was performed to model the experimental heat transfer process and showed less than 10% deviation from the measured temperatures. A sensitivity study revealed that the valve temperature is very insensitive to the heat transfer coefficient of the outer surface of the insulation layer, which is attributed to the negative feedback regulation of radiation heat transfer. To further improve the computing efficiency, a simplified model based on the lumped parameter method and the quasi-steady-state assumption was proposed and validated. This model can predict the 100 h valve temperature history in less than 1 min and showed good agreement for all of the studied cases. The ability of the simplified model to simulate the valve heating-cooling cycles at a high efficiency could accelerate the thermal design process to improve the operational flexibility of steam turbines in the future.

Valve Body’ s Thermal Characteristics Analysis for High-Temperature Electrical Gate Valves and Its Optimal Design

Study on Temperature Field of Full Welded Ball Valve During Welding Based on ANSYS

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

Optimization of Valve Body Process Based on HZCAE

Simulation and analysis of dynamic heat transfer inside a cryogenic valve under cryogenic test

Thermo-mechanical Stress Analysis of Feed-Water Valves in Nuclear Power Plants

Research on Fluid Dynamics and Thermal Characteristics in Hydraulic Valves by Thermal-Fluid-Solid Coupling Method

Fluid-solid-thermal coupling analysis of an underwater valve

Thermal-fluid-structure coupling analysis for valve plate friction pair of axial piston pump in electrohydrostatic actuator (EHA) of aircraft

Numerical Study On Temperature Field And Spool Deformation Of Throttle Slide Valve With V-Notches

Analysis of Thermal Boundary Condition and FEA Calculation of Temperature Field for the Exhaust Valve of Diesel Engine

Finite element analysis and topology optimization of direct-drive compressor valve

Fluid-solid-heat Coupling Deformation Analysis of the Valve Trims in a Multistage Pressure Reducing Valve

Thermo-mechanical Stress and Fatigue Damage Analysis on Multi-Stage High Pressure Reducing Valve

Dynamic Characteristics Analysis on High Parameter Steam Spring-Loaded Safety Valve

Effect Analysis of Temperature Gradient on Metal Bellow Mechanical Performance

An Investigation of the Temperature Distributions Inside A Spool Valve Owing to A Viscous Heating Effect

Fluid Dynamics Investigation on the Body Structure Inside a Sleeve Regulating Valve

Analysis of the Temperature and Stress Field in a Steam Turbine Bypass Valve Body

Modal and Structural Analysis on a Main Feed Water Regulating Valve under Different Loading Conditions

A Comprehensive Heat Transfer Study Inside a Steam Turbine Valve: Experiment, Numerical Simulation, and Simplified Model