Distribution and influencing factors of stress and fretting slip on the interference fit surface of composite back-up roll for cold rolling

Yonggang Dong,Heng Zhu,Jianfeng Song,Wei Shi

DOI: https://doi.org/10.3969/j.issn.1674-3644.2018.01.005

2018-01-01

Abstract:Three dimensional model of the composite back-up roll for cold rolling was built and the process of strip rolling was simulated based on ABAQUS software,then the distribution characteristics of stress and fretting slip on the interference fit surface between the roll sleeve and mandrel at different technological parameters were obtained.In addition,influences of such parameters as thickness of the roll sleeve,friction coefficient,interference magnitude,rolling force and bending force on the stress distribution and fretting slip were analyzed.The results show that the circumferential stress is the largest one on the interference fit surface,followed by the radial stress,and both are maximized in the flattened zone of the roller.The farther away from longitudinal symmetry surface of the back-up roll,the greater the fretting slip on the interference fit surface is.Circumferential relative slip value gets its maximum on the edge of flattened zone and axial relative slip value reaches its peak in the middle of flattened zone.When the outer diameter of the back-up roll is constant,roll sleeve thickness is directly proportional to the equivalent stress of the fitting surface while inversely proportional to the fretting slip amount.Friction coefficient has little impact on the equivalent stress but is in inverse proportion to the fretting slip amount.With the increase of interference magnitude,the contact stress and strain become larger,and the fretting slip increases at first then tends to be stable.The fretting slip on the fitting surface and equivalent stress in the flattened zone of the roller increase with the rise of rolling force,but bending force has little effect on both equivalent stress and fretting slip.