Abstract:The modeling of the asymmetric cold rolling process of steel strip is carried out using the Deform program. During the study, the diameter of the barrel of the upper work roll is varied from 570 to 600 mm, the diameter of the barrel of the lower work roll was left unchanged at 600 mm, and changes in the structural parameters of the deformation zone, as well as the required rolling torques and forces, are recorded. The results are obtained for the conditions of rolling strips made of low-carbon steels with a thickness of 2 mm or more, as well as 0.35...0.5 mm. It is found that the discrepancy in power between the drives of the upper and lower rolls during asymmetric rolling can reach 25 % of the power required to conduct the process on rolls with the same barrel diameter. It is also shown that the changing of the contact arc with the indicated changes in power and a decrease in the diameter of the working roll barrel from 600 to 570 mm ranges from 3 to 5 % of the length of the arc of contact in the absence of a difference in the diameters of the barrels of the rolls. Fluctuation in moments when taking into account the factor of asymmetric rolling reaches 20 % of the corresponding values typical for the technological process on rolls with the same barrel diameter. An increase in the asymmetry of the rolling process leads to a slope of the neutral section in the deformation zone with an increase in the proportion of the advance zone in the arc of contact of the upper work roll with a smaller diameter of the barrel and the strip. An assumption is made, which requires further research, about the possibility of creating only one advance section along the entire length of the interaction of the roll with a smaller diameter of the barrel and the strip. Such a structure of the contact zone is theoretically able to reduce the required power of the main drive.

Effect of Interstand Tensions on Lubrication Regime in Cold Strip Rolling with O/W Emulsion

Relationship of Oil Composition and Lubricating Characteristics in Cold Rolling Aluminum Strips

Analysis and Prospects of Lubrication and Friction Characteristics in Cold Strip Rolling: A Review

Application and Development of Emulsion Lubricant Used for Aluminum Strip Hot Rolling

AN INVESTIGATION OF THE STABILITY AND LUBRICITY OF EMULSIONS FOR STRIP COLD ROLLING

Rolling of Thin Strip and Foil: Application of a Tribological Model for “mixed” Lubrication

Effect of Ageing of Rolling Oil on the Performance of Cold‐Rolled Steel

Effect of nano additives in rolling emulsion on lubrication of strip cold rolling

The effect of oxide scale of stainless steels on friction and surface roughness in hot rolling

The influence of water-based nanolubrication on mill load and friction during hot rolling of 304 stainless steel

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

A robust model for rolling of thin strip and foil

Investigation of the Film Formation Mechanism of Oil-in-water (O/W) Emulsions

Study on the Formulation of Emulsion Oil for Cold Rolling Copper Sheet and Evaluation of Its Lubrication Performance

Analytical Study of Viscoelastic Fluid During Forward Roll Coating Process under Lubrication Approximation Theory

The effect of emulsifier concentration on the lubricating properties of oil-in-water emulsions

Analysis of Rolling Force and Friction in Hot Steel Rolling with Water‐Based Nanolubrication

Research of the Indirect Friction Sensor for Prediction of Contact Stress by Improved Inverse Method in Strip Rolling

Numerical simulation of cold longitudinal asymmetric rolling process

Effect of Tension Coiler on Temperature Field among Layers for Hot Strip

The central strain analytical modeling and analysis for the plate rolling process