Abstract:A novel method is proposed for accurately determining the local wall friction through the near-wall measurement of time-average velocity profile in a Type-A turbulent boundary layer (TBL). The method is based on the newly established analytical wall-law in Type-A TBL. The direct numerical simulations (DNS) data of turbulence on a zero-pressure-gradient flat-plate (ZPGFP) is used to demonstrate the accuracy and the robustness of the approach. To verify the reliability and applicability of the method, a two-dimensional particle image velocimetry (PIV) measurement was performed in a ZPGFP TBL with a low-to-moderate Reynolds number (Re). Via utilizing the algorithm of single-pixel ensemble correlation (SPEC), the velocity profiles in the ZPGFP TBL were resolved at a significantly improved spatial resolution, which greatly enhanced the measurement accuracy and permitted us to accurately capture the near-wall velocity information. The accuracy of the approach is then quantitatively validated for the high Reynolds number turbulence using the ZPGFP TBL data. The research demonstrates that the current method can provide the precise estimation of wall friction with a mean error of less than 2%, which not only possesses the advantage of its insensitivity to the absolute wall-normal distance of the measuring point, but also its capability of providing an accurate prediction of wall shear stress based on fairly sparse experimental data on the velocity profile. The current study demonstrates that the wall shear stress can be accurately estimated by a velocity even at a single-point either measured or calculated in the near-wall region.

Analysis of Wall Sliding Characteristics about Abrasive Flow Carrier in Pipe

The Effect of Slip Distribution on Flow Past a Circular Cylinder

Analysis of Flowing Characteristics of Abrasive Flow Machining in Slit

Influence of viscoelasticity on grinding effect in abrasive flow machining

Research for the Wall Wear of Horizontal Pipeline in Swirling Flow Pneumatic Transport Based on the Computational Fluid Dynamics Simulation Analysis

The Wall-Slip Testing System of Lubricating Grease in Flowing Pipe

Falling Film Flow of a Viscoelastic Fluid along a Wall

The Influence of Wall Boundary Modeling on the Unphysical Frictional Loss Inside Horizontal Main Drain

Analysis on flow characteristics of dynamic ice slurry

Energy Analysis of a Quasi-Two-Dimensional Friction Model for Simulation of Transient Flows in Viscoelastic Pipes

Numerical Simulation Analysis of Four‐stage Variable Diameter Pipe for Solid–liquid Two‐phase Abrasive Flow

Velocity Distribution and Slip Velocity of Large Particle Slurry Flow in Pipe

Fluid Model of Sliding Suction Cup of Wall-climbing Robots

Transient Friction Models in Pressurized Pipes

Influence of Wall Structure on the Laminar Coupling Flow

Particle Trajectories in Pipe Flow Considering Particle-Wall Collisions

Material Removal Rate Model of High Viscoelastic Fluid Abrasive Finishing

Influence of wall slip of lubricants on performance of elastohydrodynamic lubrication in line contact

A new model for fluid velocity slip on a solid surface

Theoretical and Experimental Research on the Friction Coefficient of Water Lubricated Bearing with Consideration of Wall Slip Effects

Accurate Method for Estimating Wall-Friction Based on Analytical Wall-Law Model