Abstract:In this study, the machining mechanism of abrasive flow machining (AFM) microstructures was analyzed in depth according to the transmission morphology and rheological behaviors of the abrasive media. The transmission morphology demonstrated the excellent combination of the polymer melt with abrasive grains at the interface, indicating that the polymer melt, combined with the uniform distribution of the polymer chains, could exert a harmonious axial force on the abrasive grains. Based on the rheological behavior analysis of the abrasive media, for example, the stress relaxation and moduli of storage and loss, a machining mechanism model was established incorporating the effect of microplastic deformation and continuous viscous flow, which was further verified by the grooves along the flow direction. In addition, the Phan-Thien-Tanner (PTT) model combined with a wall slipping model was employed to simulate the machining process for the first time here. The value of the simulated pressure (1.3 MPa) was similar to the measured pressure (1.45 MPa), as well as the simulated volumetric rate (0.011 4 mL/s) to the measured volumetric rate (0.067 mL/s), which further proved the validity of the simulation results. The flow duration (21 s) derived from a velocity of 1.2 mm/s further confirmed the residual stretched state of the polymer chains, which favored the elasticity of the abrasive media on the grains. Meanwhile, the roughly uniform distribution of the shear rate at the main machining region exhibited the advantages of evenly spread storage and loss moduli, contributing to the even extension of indentation caused by the grains on the target surface, which agreed with the mechanism model and machined surface morphology.

Influence of viscoelasticity on grinding effect in abrasive flow machining

Analysis of Flowing Characteristics of Abrasive Flow Machining in Slit

Study on Grinding Force Model in Ultrasonic Vibration Assisted Grinding for Ductile Materials

Material Removal Rate Model of High Viscoelastic Fluid Abrasive Finishing

Analysis of Wall Sliding Characteristics about Abrasive Flow Carrier in Pipe

Impact of fluid abrasive viscosity on machining performance

The Analytical Model of Ball-Spinning Force for Processing an Annular Groove on the Inner Wall of a Steel Tube

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Research on the underlying mechanism behind abrasive flow machining on micro-slit structures and simulation of viscoelastic media

Influence of Thermal-mechanical Coupling of Single Particle on Grinding Surface Roughness

Theoretical and experimental investigation into the formation mechanism of surface waviness in ultra-precision grinding

Interference and grinding characteristics in ultra-precision grinding of thin-walled complex structural component using a ball-end grinding wheel

Grinding force assessment in tangential ultrasonic vibration-assisted grinding gear: Analytical model and experimental verification

Establishment of dynamic grinding force model for ultrasonic-assisted single abrasive high-speed grinding

The influence of wear volume on surface quality in grinding process based on wear prediction model

Force modeling of vertical surface grinding considering wheel-workpiece contact geometry

Introducing abrasive wear into undeformed chip thickness modeling with improved grain kinematics in belt grinding

Simulation Analysis of Cluster Effect of High-Shear Low-Pressure Grinding with Flexible Abrasive Tools

Modeling and Simulation of Temperature Field in High-Shear and Low-Pressure Grinding with Liquid-Body-armor-like Grinding Wheel

Modeling of Grinding Force in Constant-Depth-Of-Cut Ultrasonically Assisted Grinding

Influence of wall slip of lubricants on performance of elastohydrodynamic lubrication in line contact