Abstract:A novel Wheatstone bridge adjustment circuit with both rough-tuning and fine-tuning functions is designed for balancing the Wheatstone bridge in this article. Firstly, the parametric circuit structure is constructed to facilitate the design of rough-tuning and fine-tuning sub-circuit parameters; Secondly, the quantitative index of Wheatstone bridge imbalance is defined, and the parameter design flow of the rough-tuning sub-circuit, which consists of two sets of series-parallel-resistor (SPR) structures that are, respectively, connected in parallel with the two branches of one half-bridge, is given to directly weaken the initial bridge imbalance in the manufacturing stage. Theoretical analysis results show that the SPR structure can effectively approach any expected value and reduce the number of fixed resistor types. Thirdly, parameters of the fine-tuning sub-circuit, which consists of a resistor and a digital-to-analog converter (DAC), are optimized based on any expected adjustable range. Adjusting the DAC input to seek the middle value of an analog-to-digital converter (ADC) output, indirectly eliminates the additional bridge imbalance caused by mechanical assembly stress, gravity, ambient temperature, etc., in the application stage. Then the influence of the fine-tuning parameters on linear fitting coefficients of the output versus input of the Wheatstone bridge is analyzed theoretically. The results show that the DAC output voltage only has a significant linear impact on the intercept coefficient, while its impact on the scale coefficient is negligible. Finally, the effectiveness of the adjustment circuit is verified on a six-axis force/torque sensor that is developed for an Experimental Module Manipulator (EMM) in the Chinese Space Station (CSS).

Effect of Sensitivity of Wheatstone Electrical Bridge Using Constant-Current Source

Comparison of different sensitivity matrices relating element elongations to structural response of pin-jointed structures

DISSCUSSION ABOUT VOLTAGE-SENSITIVE WHEATSTONE ELECTRICAL BRIDGE

A New Approach for Analyzing the Effect of Non-Ideal Power Supply on a Constant Current Underwater Cabled System

Design and Optimization of Wheatstone Bridge Adjustment Circuit for Resistive Sensors

Characteristics of Controlled Bridge Circuit and Its Application in Magnetic Field Induction Measurement

Alternating frequency range influence on the conductivity measurements of electrolyte solutions using alternating current bridge method

Simulation and optimization of conductor structural parameters of free-space hall-effect current sensor

Half bridge configurated magneto-resistive sensors with flux guide structure for enhancing sensitivity

A Large Current Detection System Based on Dual Wheatstone Bridge Magnetoresistive Sensor

Research on Rational Post Successive Prestress Tension Sequence of Simply Supported and Continuous Box Girder Bridge

Study on feasibility of ramp current sensitivity testing method

Analysis for Sensitivity of Control Parameters in Construction of PC Continuous Steel Structure Bridges

Environmental Effects and Output-Only Model Identification of Continuous Bridge Response

High-Sensitivity and Wide-Range Resistance Measurement Based on Self-Balancing Wheatstone Bridge and Gated Recurrent Neural Network

Enhancing Undergraduate Physics Education: A Pedagogical Exploration of the Wheatstone Bridge with Symmetry and Simulation

A 20 μ W, 0.05mm2 Duty-Cycled Resistor and Frequency-Locked-Loop-based Wheatstone Bridge Interface for Low Resistance Sensing Systems

Analysis of Parameter Sensitivity of Construction Control of Multi Span PC Continuous Beam Bridge with Corrugated Steel Webs

An Experimental Approach for Characterisation of Concrete Damage Using the Wheatstone Bridge Circuit

Study on Ramp Current Method and Up-and-down Method for Sensitivity Testing of Initiating Device

High Sensitivity Pressure Sensor Using Tandem Wheatstone Bridge for Low Pressures