Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Analysis of Parameter Sensitivity of Construction Control of Multi Span PC Continuous Beam Bridge with Corrugated Steel Webs

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Investigation of elasto-plastic seismic response analysis method for complex steel bridges

Evaluation of Thermal Effects on Cable Forces of a Long-Span Prestressed Concrete Cable–Stayed Bridge

Mechanical Behavior of Box Girder Bridge with Partial Corrugated Steel Webs

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

THE INFLUENCE OF LINEAR AND NON LINEAR FACTORS ON THE CONSTRUCTION CONTROL ANALYSIS OF CABLE-STAYED BRIDGES

Stress Behavior in Embedded Connection Zone of Box Girder with Corrugated Steel Webs

Analysis for Sensitivity of Control Parameters in Construction of PC Continuous Steel Structure Bridges

Time-dependent behavior of PC box girder bridges considering non-uniform shrinkage and creep

SIMULATION FOR CONSTRUCTION PROCESS OF P.C. CONTINUOUS RIGID FRAME BRIDGE

Spatial Simulating Analysis Of Prestressing Force Effect Of Long Span Prestressed Concrete Box Girder Bridge

Parametric Analysis of Seismic Response of PC Continuous Beam Bridge with Corrugated Steel Webs

Influence analysis of group studs stiffness in accelerated construction steel-concrete composite small box girder bridges

Field Test and Analysis for the Static and Dynamic Behaviour of Multi-Box Steel Concrete Composite Girder Bridge

Spatial behavior and strengthening analysis of fabricated PC hollow slab beam bridge with hinge joints

Analysis of Temperature Stress in Bridges Considering Vertical and Transverse Temperature Gradient

Analysis of Ultimate Loading Capacity of the Prestressed Concrete Curved Bridge

Influence of Effective Prestress on Ultimate Bearing Capacity for Large-Span Prestressed Concrete Bridge

Reinforcement Analysis of an Old Multi-Beam Box Girder Based on a New Embedded Steel Plate (ESP) Strengthening Method

Simulating analysis of cantilever casting of prestressed concrete bridge