Abstract:AgSbSe2 is a typical member of cubic I–V–VI2 semiconductors, which are known for their extremely low lattice thermal conductivity (κl). However, the low electrical conductivity of AgSbSe2, below ∼10 S cm–1 at room temperature, has hindered its thermoelectric performance. In this work, single-phase AgSbSe2 bulk samples with much higher electrical conductivity were synthesized via self-propagating high-temperature synthesis (SHS) combined with spark plasma sintering (SPS) for the first time. Pb doping through the nonequilibrium process further increases the electrical conductivity to >100 S cm–1. Furthermore, continuously increased effective mass md* can be achieved upon Pb doping because of the multiple degenerate valence bands of AgSbSe2 and the energy-filtering effect induced by in situ-formed nanodots. The simultaneous enhancement of both the electrical conductivity and Seebeck coefficient contributes to an unprecedentedly high average power factor of 6.75 μW cm–1 K–2. Meanwhile, the introduced dense grain boundaries and point defects enhance the phonon scattering and consequently suppress κl, yielding a high ZT value of 1.2 at 723 K in AgSb0.94Pb0.06Se2. This study opens a new avenue for rapid, low-cost, large-scale production of AgSbSe2-based materials and demonstrates that Pb-doped AgSbSe2 prepared via the SHS–SPS method is a promising candidate for thermoelectric applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10508?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10508</a>.Part of the thermoelectric properties of AgSb1–xPbxSe2, temperature-dependent electronic thermal conductivity, Lorentz constant, diffusivity, heat capacity, and the elemental quantitative analysis by EPMA for AgSb1–xPbxSe2 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10508/suppl_file/am0c10508_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Thermoelectric Properties of PbSe-PbS Solid Solutions Prepared by Mechanical Alloying Method and High Pressure Sintering

Enhanced thermoelectric performance of n-type PbTe through introducing PbSe by a fast preparation method

Rapid Synthesis of PbSe by MA and HPS and Its Thermoelectric Properties

Electrical and thermal transport properties of Pb1-xSnxSe solid solution thermoelectric materials.

Enhanced Thermoelectric Performance of PbSe Co-Doped with Ag and Sb

Thermoelectric SnS and SnS-SnSe Solid Solutions Prepared by Mechanical Alloying and Spark Plasma Sintering: Anisotropic Thermoelectric Properties.

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

Thermoelectric Properties of PbTe1−Se Alloys Prepared by High Pressure

Thermoelectric transport properties of polycrystalline SnSe alloyed with PbSe

Enhanced Low Temperature Thermoelectric Performance and Weakly Temperature-Dependent Figure-of-merit Values of PbTe–PbSe Solid Solutions

Facile synthesize and enhanced thermoelectric performance of PbS with Cl doping and PbSe alloying

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

High Thermoelectric Efficiency Of N-Type Pbs

Thermoelectric properties of Na-doped PbTe0 .8-xSe0 .2 Sx alloys

Synthesis of SnSe 1– x S x Polycrystals with Enhanced Thermoelectric Properties Via Hydrothermal Methods Combined with Spark Plasma Sintering

Enhanced Thermoelectric Performance of Ag0.8Pb18SbTe20 Alloyed with Se

Comprehensive Investigation on the Thermoelectric Properties of P‐type PbTe‐PbSe‐PbS Alloys

Bridging the miscibility gap towards higher thermoelectric performance of PbS

High Pressure Synthesis and Thermoelectric Properties of PbSe

Electrical Transport and Thermoelectric Properties of Te–Se Solid Solutions

High Pressure Synthesis and Thermoelectric Performance of CoSbS1-xSex (x=0 similar to 0.3)