Abstract:PbSe has been expected to be a competitor of the excellent thermoelectric material PbTe, whereas its performance has proved to be limited by its intrinsic electronic structure. In this work, the improved thermoelectric performance of PbSe originating in the novel spin‐orbit coupling effect is reported. By alloying with NaSbSe2, valence band convergence and bandgap enlargement are achieved in PbSe, resulting in a significantly enlarged Seebeck coefficient. Theoretical calculations indicate that a modified electronic structure by spin‐orbit coupling would lead to exotic thermoelectric properties and that it prefers a lower carrier concentration than the known optimal value for PbSe. When Cd‐doping is introduced to decrease the carrier concentration, a high peak ZT of 1.6 at 850 K and a remarkable average ZT of 0.95 are obtained in Pb0.8Na0.1Sb0.08Cd0.02Se. Among the reported high ZT PbSe‐based compounds, the sample exhibits the highest Seebeck coefficient and lowest thermal conductivity. This study provides an insight into band structure tuning of Lead chalcogenides and promotes a new strategy for the optimization of thermoelectric performance. Owing to the band convergence induced by spin‐orbit coupling, the solid solution of PbSe‐NaSbSe2 exhibits a much higher Seebeck coefficient than the previously reported PbSe‐based materials. The optimized PbSe‐NaSbSe2 sample reaches a remarkable average ZT of 0.95 (400–850 K) for improved performance within the large temperature range.

Enhanced Thermoelectric Performance of Ag0.8Pb18SbTe20 Alloyed with Se

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Thermoelectric properties of Na-doped PbTe0 .8-xSe0 .2 Sx alloys

Improved thermoelectric performance in PbSe–AgSbSe2 by manipulating the spin-orbit coupling effects

High Thermoelectric Performance of Ge1−xPbxSe0.5Te0.5 Due to (pb, Se) Co-Doping

Enhanced Thermoelectric Performance of PbSe Co-Doped with Ag and Sb

Thermoelectric Properties of PbTe1−Se Alloys Prepared by High Pressure

Improved Thermoelectric Performance of Tellurium by Alloying with a Small Concentration of Selenium to Decrease Lattice Thermal Conductivity

Enhanced Low Temperature Thermoelectric Performance and Weakly Temperature-Dependent Figure-of-merit Values of PbTe–PbSe Solid Solutions

Band convergence and nanostructure modulations lead to high thermoelectric performance in SnPb0.04Te-y% AgSbTe2

Enhancing the Thermoelectric Performance of GeSb4Te7 Compounds via Alloying Se

Modulating the Valence of Ga and the Deep Level Impurity for High Thermoelectric Performance of N-Type Pb0.98Ga0.02Te1-xSex Compounds

Modulated Fermi Level and Relaxed Lattice Strain Leading to Enhanced Thermoelectric Properties in AgSbSe 2

Enhanced thermoelectric perfromance in cubic form of SnSe stabilized through enformatingly alloying AgSbTe2

Co-alloying of Sn and Te enables high thermoelectric performance in Ag9GaSe6

High Thermoelectric Properties for Sn-doped AgSbSe 2

Comprehensive Investigation on the Thermoelectric Properties of P‐type PbTe‐PbSe‐PbS Alloys

Enhanced Thermoelectric Performance of N-Type PbSe by Pyrite FeSe2 Alloying

Ag, Pb co-doped SnSe high performance thermoelectric materials

Boosting the Thermoelectric Performance of PbSe from the Band Convergence Driven By Spin‐Orbit Coupling

High-performance Ag0.8Pb18+xSbTe20 Thermoelectric Bulk Materials Fabricated by Mechanical Alloying and Spark Plasma Sintering