Abstract:AgSbSe2 is a typical member of cubic I–V–VI2 semiconductors, which are known for their extremely low lattice thermal conductivity (κl). However, the low electrical conductivity of AgSbSe2, below ∼10 S cm–1 at room temperature, has hindered its thermoelectric performance. In this work, single-phase AgSbSe2 bulk samples with much higher electrical conductivity were synthesized via self-propagating high-temperature synthesis (SHS) combined with spark plasma sintering (SPS) for the first time. Pb doping through the nonequilibrium process further increases the electrical conductivity to >100 S cm–1. Furthermore, continuously increased effective mass md* can be achieved upon Pb doping because of the multiple degenerate valence bands of AgSbSe2 and the energy-filtering effect induced by in situ-formed nanodots. The simultaneous enhancement of both the electrical conductivity and Seebeck coefficient contributes to an unprecedentedly high average power factor of 6.75 μW cm–1 K–2. Meanwhile, the introduced dense grain boundaries and point defects enhance the phonon scattering and consequently suppress κl, yielding a high ZT value of 1.2 at 723 K in AgSb0.94Pb0.06Se2. This study opens a new avenue for rapid, low-cost, large-scale production of AgSbSe2-based materials and demonstrates that Pb-doped AgSbSe2 prepared via the SHS–SPS method is a promising candidate for thermoelectric applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10508?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10508</a>.Part of the thermoelectric properties of AgSb1–xPbxSe2, temperature-dependent electronic thermal conductivity, Lorentz constant, diffusivity, heat capacity, and the elemental quantitative analysis by EPMA for AgSb1–xPbxSe2 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10508/suppl_file/am0c10508_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

High Pressure Synthesis and Thermoelectric Properties of PbSe

Enhanced thermoelectric performance of n -type PbTe bulk materials fabricated by semisolid powder processing

Thermoelectric properties of nonstoichiometric PbTe prepared by HPHT

Extremely anisotropic thermoelectric properties of SnSe under pressure

Pressure-induced superconductivity and phase transition in PbSe and PbTe

Influence of pressure on phase transition, electronic and thermoelectric properties of SnSe

Structural Changes in Thermoelectric SnSe at High Pressures

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

Facile synthesize and enhanced thermoelectric performance of PbS with Cl doping and PbSe alloying

Intrinsically low thermal conductivity of tetragonal-structured PbSe2

Multiple valence bands convergence and strong phonon scattering lead to high thermoelectric performance in p-type PbSe

Enhanced thermoelectric performance of n-type PbTe through introducing PbSe by a fast preparation method

Realizing Ultrahigh Thermoelectric Performance in n‐Type PbSe Through Lattice Planification and Introducing Liquid‐Like Cu Ions

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

High Pressure Synthesis, Structure and Thermoelectric Properties of Bicucho(Ch = S, Se, Te)

Data-driven Exploration of New Pressure-induced Superconductivity in PbBi$_2$Te$_4$ with Two Transition Temperatures

Chemical Pressure-Driven Band Convergence and Discordant Atoms Intensify Phonon Scattering Leading to High Thermoelectric Performance in SnTe

Engineering atomic-level crystal lattice and electronic band structure for extraordinarily high average thermoelectric figure of merit in n-type PbSe

Effect of sintering pressure on electrical transport and thermoelectric properties of polycrystalline SnSe

High-pressure synthesis and thermoelectric performance of tellurium doped with bismuth

Pressure Tuning of Thermoelectric Performance in FeNbSb