Abstract:Cu3SbSe4, featuring its earth-abundant, cheap, nontoxic and environmentally friendly constituent elements, can be considered as a promising intermediate temperature thermoelectric (TE) material. Herein, a series of p-type Bi-doped Cu3Sb1−xBixSe4 (x = 0–0.04) samples were fabricated through melting and hot pressing process, and the effects of isovalent Bi-doping on their TE properties were comparatively investigated by experimental and computational methods. TEM analysis indicates that Bi-doped samples consist of Cu3SbSe4 and Cu2−xSe impurity phases, which is in good agreement with the results of XRD, SEM and XPS. For Bi-doped samples, the reduced electrical resistivity (ρ) caused by the optimized carrier concentrations and enhanced Seebeck coefficient derived from the densities of states near the Fermi level give rise to a high power factor of ~ 1000 µWm−1 K−2 at 673 K for the Cu3Sb0.985Bi0.015Se4 sample. Additionally, the multiscale defects of Cu3SbSe4-based materials involving point defects, nanoprecipitates, amorphous phases and grain boundaries can strongly scatter phonons to depress lattice thermal conductivity (κlat), resulting in a low κlat of ~ 0.53 Wm−1 K−1 and thermal conductivity (κtot) of ~ 0.62 Wm−1 K−1 at 673 K for the Cu3Sb0.98Bi0.02Se4 sample. As a consequence, a maximum ZT value ~ 0.95 at 673 K is obtained for the Cu3Sb0.985Bi0.015Se4 sample, which is ~ 1.9 times higher than that of pristine Cu3SbSe4. This work shows that isovalent heavy element doping is an effective strategy to optimize thermoelectric properties of copper-based chalcogenides.

High Pressure Synthesis, Structure and Thermoelectric Properties of Bicucho(Ch = S, Se, Te)

Fast synthesis and thermoelectric properties of BixCu2−3xSe0.95Te0.05 (x = 0, 0.001, 0.002, 0.003, 0.004)

Band Structure Manipulated by High Pressure-Assisted Te Doping Realizing Improvement in Thermoelectric Performance of BiCuSeO System

Enhanced thermoelectric performance of BiCuSO by Pb doping and Se alloying

Highly Enhanced Thermoelectric and Mechanical Properties of Bi-Sb-Te Compounds by Carrier Modulation and Microstructure Adjustment

Mechanical Alloying and Spark Plasma Sintering of Bicuseo Oxyselenide: Synthesis Process and Thermoelectric Properties

Thermoelectric properties of (Cu,Te) co-doped CoSb 3 synthesized by high-pressure and high-temperature

Enhanced thermoelectric performance of BiCuSeO through composite structuring with Pb-and La-doped components

Enhanced Thermoelectric Properties of Cu3SbSe4 Compounds by Isovalent Bismuth Doping

Complex Electronic Structure and Compositing Effect in High Performance Thermoelectric BiCuSeO.

Electronic Structure of a Thermoelectric Material: BiCuSO

Synergistically optimized electron and phonon transport of p-type BiCuSeO oxyselenides via Pb dopant and Te composite

Synthesis, Structure & Properties of CuBiSeCl2: A Chalcohalide Material with Low Thermal Conductivity

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu1.8S Via Carrier Concentration Regulation and Multiscale Phonon Scattering

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu 1.8 S via Carrier Concentration Regulation and Multiscale Phonon Scattering

The New Thermoelectric Semiconductors Pb5Sb12+xBi6−xSe32 with Ultralow Thermal Conductivity

Remarkable Enhancement in Thermoelectric Performance of BiCuSeO by Cu Deficiencies.

Pressure induced structural transitions in CuSbS 2 and CuSbSe 2 thermoelectric compounds

Quasi-layered Crystal Structure Coupled with Point Defects Leading to Ultralow Lattice Thermal Conductivity in n-Type Cu 2.83 Bi 10 Se 16

High Thermoelectric Performance of Bi 1− X K X CuSeO Prepared by Combustion Synthesis

Enhancement of low-temperature thermoelectric performance via Pb doping in Cu3SbSe4