Abstract:In this paper, how the phase modulation index’s drift affects an open-loop resonator fiber optic gyro’s (RFOG’s) performance is discussed. By using the ratio of the second to fourth harmonic (2nd/4th harmonic), a harmonic feedback technique is proposed to suppress this drift. It is found that the phase modulation index’s drift would lead to a significant measurement error, which increases with rotation rate. It is proven that there exists an approximately linear correlation between phase modulation index and 2nd/4th harmonic. Using this correlation, the 2nd/4th harmonic feedback technique is applied to the open-loop RFOG to stabilize the phase modulation index. Although the phase modulation index slightly deviates from its optimal value in the dynamic state with this technique, it is proven that the induced backscatter noise could be neglected. The test results indicate that the phase modulation index’s drift with this technique is reduced to about 22% of that without suppression technique, and the stabilities of gyro output signal are respectively improved by about 29% and 31% under 5deg/s and 10deg/s when this technique is used. It is concluded that the 2nd/4th harmonic feedback technique does work in suppressing the phase modulation index’s drift.

Research of the Key Technologies on Closed-Loop IFOG

The Research Of Digital Close-Loop Depolarized Fog

Method and System for IFOG Output Delay Time Measurement

IFOG Output Fluctuation Caused by Electrostriction Effect and Its Solution

Research on digital signal detection method in closed loop fiber gyros

Digital System Study Applied to Performance Detection of Optic Fiber Gyroscope

Research on the Frequency-Dependent Halfwave Voltage of a Multifunction Integrated Optical Chip in an Interferometric Fiber Optic Gyroscope.

A Harmonic Subtraction Technique to Suppress Intensity Modulation Induced Kerr Effect Drift in a Closed-Loop RFOG

Design and realization for FOG pure lag test system

Closed-loop RFOG Based on Square Wave Quadrature Demodulation

Review of Development of Interferometric Fiber-Optic Gyroscopes

Design and Implementation of the Digital Detection Circuit for RFOG Based on a Single FPGA

A closed-loop RFOG based on digital serrodyne and sine modulations with two LiNbO3 phase modulators

A Comparison Angular Vibration Calibration Approach Based on the IFOG

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

Modulation Spectrum Analysis and Optimization for Closed-Loop RFOG under Dynamic Condition

An Open-Loop RFOG Based on Harmonic Division Technique to Suppress LD's Intensity Modulation Noise

A Miniaturized Compact Open-Loop RFOG with Demodulation Signal Compensation Technique to Suppress Intensity Modulation Noise

Digital Signal Processing for a Closed-Loop Resonant Fiber Optic Gyro

Receng Progress on Resonator Fiber Optic Gyro

A Low‐complexity Scheme for Enlarging the Dynamic Range of the Open‐loop I‐FOG