Abstract:An optical fiber ring resonator (OFRR) is the key rotation-sensing element in the resonator fiber optic gyro (R-FOG). In comparing between different OFRR types, a simulation model that can apply to all cases is set up. Both the polarization crosstalk and polarization-dependent loss in the coupler are fully investigated for the first time to our knowledge. Three different splicing schemes, including a single 0 degrees, a single 90 degrees, and twin 90 degrees polarization axis rotated spices, are compared. Two general configurations of the OFRR are considered. One is a reflector OFRR, the other is a transmitter OFRR. This leads to six different OFRR types. The output stability of the R-FOG with six OFRR types is fully investigated theoretically and experimentally. Additional Kerr noise due to the polarization fluctuation is discovered. The OFRR with twin 90 degrees polarization axis rotated splices is of lower additional Kerr noise and hence has better temperature stability. As the coupler is polarization dependent, we notice that in a reflector OFRR, the straight-through component of the output lightwave, which can be isolated by a transmitter configuration, would produce large polarization fluctuation-induced noise. The experimental results show that the bias stability of the transmitter OFRR is 8 times improved over that of the reflector OFRR, which is in accord with the theoretical analysis. By the analysis and experiments above, it is reasonable to make a conclusion that an R-FOG based on a transmitter OFRR with twin 90 degrees polarization axis rotated splices is of better temperature stability and smaller additional Kerr effect noise. (C) 2012 Optical Society of America

IFOG Output Fluctuation Caused by Electrostriction Effect and Its Solution

Research on the Frequency-Dependent Halfwave Voltage of a Multifunction Integrated Optical Chip in an Interferometric Fiber Optic Gyroscope.

Influence of the Modulation Phase Error on Bias Error in Interferometric Fiber Optic Gyroscope

Temperature Modeling of Modulation Phase Error in the Integrated Optical Chip for Closed-Loop Interferometric Fiber Optic Gyroscope

Study of Wavelength Temperature Stability of Multifunctional Integrated Optical Chips Applied on Fiber Optic Gyroscopes

Angle error from vibrating in tri-axial interferometric fiber optic gyroscopes and the evaluation with dual-laser Doppler vibrometers

Influence of intensity noise on the resonant fiber optic gyroscope and restraining

A New Optical Method for Suppressing Radial Magnetic Error in a Depolarized Interference Fiber Optic Gyroscope.

Nonreciprocal Phase Error Caused by Orthogonal Magnetic Field in a Polarization-Maintaining Fiber-Optic Gyro

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Review of Development of Interferometric Fiber-Optic Gyroscopes

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

A Miniaturized Compact Open-Loop RFOG with Demodulation Signal Compensation Technique to Suppress Intensity Modulation Noise

Laser frequency noise induced error in resonant fiber optic gyro due to an intermodulation effect.

Performance Improvement of a Resonant Fiber Optic Gyroscope with a Hybrid Photonic Crystal Fiber Ring Resonator.

Effective Suppression of Residual Coherent Phase Error in a Dual-Polarization Fiber Optic Gyroscope.

Polarization-Induced Noise In Resonator Fiber Optic Gyro

Improving the Scale Factor Thermal Stability of Resonant Fiber-Optic Gyroscopes by Tracking the Half-Wave Voltage of the Phase Modulator

Dynamic Characteristics of R-FOG Based on the Triangle Wave Phase Modulation Technique

Zero-deviation Effect in a Resonator Optic Gyro Caused by Nonideal Digital Ramp Phase Modulation