Abstract:Resonator Fiber optic gyro (RFOG) is a high accuracy inertial rotation sensor based on the Sagnac effect. The optical fiber ring resonator (OFRR) is the key rotation sensing element. The backscattering characteristics of the OFRR are fully investigated. The Rayleigh backscattering dominates the backscattering spectrum with the input power below the threshold. High carrier suppression is crucial to reduce this Rayleigh backscattering error. Being different from the intrinsic Rayleigh scattering of the fiber, the stimulated Brillouin scattering (SBS) in the OFRR should be avoided. This is because the finesse and the resonance notch depth of the OFRR decrease for the pump depletion through the SBS process. The shot noise limited sensitivity (SLS) of the RFOG is improved by increasing the input power. Through analysis, it is found that the threshold input power is improved after phase modulation. The SLS of the RFOG is analyzed at different modulation parameters and its relevant SBS threshold. Accordingly, the optimized modulation frequency and the corresponding maximum input power are all obtained. A simple method of testing the frequency shift in the SBS is also proposed. In this method, the central frequency of the laser source is locked to the resonance frequency of the OFRR in one direction. A steady SBS light is observed and its frequency shift is measured together.

Laser frequency noise induced error in resonant fiber optic gyro due to an intermodulation effect.

Influence of intensity noise on the resonant fiber optic gyroscope and restraining

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Laser Frequency Noise Measurement in a Resonant Fiber Optic Gyro

Evaluation and Suppression of the Effect of Laser Frequency Noise on Resonant Fiber Optic Gyroscope

IFOG Output Fluctuation Caused by Electrostriction Effect and Its Solution

An Open-Loop RFOG Based on Harmonic Division Technique to Suppress LD's Intensity Modulation Noise

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

Laser Frequency Noise Power Spectral Density Measurement Technology and Its Application to Resonant Optical Fiber Gyroscope

How Laser Diode (LD) Intensity Modulation Induced by Current Tuning Affects the Performance of an Open-loop Resonator Fibre Optic Gyro (R-FOG) with Sinusoidal Wave Modulation

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

Reduction of relative intensity noise in a broadband source-driven RFOG using a high-frequency modulation technique

Laser Frequency Noise Limited Sensitivity In A Resonator Optic Gyroscope

Modulation Spectrum Analysis and Optimization for Closed-Loop RFOG under Dynamic Condition

A Miniaturized Compact Open-Loop RFOG with Demodulation Signal Compensation Technique to Suppress Intensity Modulation Noise

Signal processing improvement of passive resonant fiber optic gyroscope using a reciprocal modulation-demodulation technique

Analysis of the Kerr Effect in a Resonator Fibre Optic Gyro (R-FOG) Under Accompanying Intensity Modulation with a Laser Diode

Zero-deviation Effect in a Resonator Optic Gyro Caused by Nonideal Digital Ramp Phase Modulation

Resonator Fiber Optic Gyro Employing a Semiconductor Laser.

Research Progress of the Resonant Fiber Optic Gyroscope Technology

Full investigation of the backscattering in resonator fiber optic gyro