Abstract:Aiming at the demodulation signal compensation technique for intensity modulation noise suppressing in a digital RFOG, which is based on the detection of closed loop’s second-harmonic, the quantization precision for second-harmonic is discussed and optimized. By analyzing second-harmonic’s fluctuation under the intensity modulation noise equal to shot noise limited sensitivity, the expression for the required minimum quantization bits of second-harmonic signal is obtained. Based on this expression, numerical simulations are carried out to optimize the quantization bits in a digital RFOG in detail. Based on over-sampling technique, the stability of gyro output signal with different quantization bits and rotation rates is tested to verify the theoretically analyzed results. It is concluded that the minimum quantization bits of second-harmonic is related to the rotation rate and the ratio of second-harmonic’s maximum to minimum, and it gets larger as these two parameters are increased. Especially, the required minimum quantization bits for second-harmonic would generally exceed that supported only by hardware circuits, which leads to the adoption of over-sampling technique. And it is proven that the quantization precision improvement for second-harmonic, realized by the over-sampling technique, does work in improving the effect of intensity modulation noise suppressing.

An Open-Loop RFOG Based on Harmonic Division Technique to Suppress LD's Intensity Modulation Noise

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

A Harmonic Subtraction Technique to Suppress Intensity Modulation Induced Kerr Effect Drift in a Closed-Loop RFOG

A Miniaturized Compact Open-Loop RFOG with Demodulation Signal Compensation Technique to Suppress Intensity Modulation Noise

Fiber Optic Gyroscope Noise Reduction with Fiber Ring Resonator

Influence of intensity noise on the resonant fiber optic gyroscope and restraining

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Modulation Spectrum Analysis and Optimization for Closed-Loop RFOG under Dynamic Condition

A closed-loop RFOG based on digital serrodyne and sine modulations with two LiNbO3 phase modulators

Closed-loop RFOG Based on Square Wave Quadrature Demodulation

Closed-loop resonant fiber optic gyro with an improved digital serrodyne modulation.

Reduction of relative intensity noise in a broadband source-driven RFOG using a high-frequency modulation technique

Optimization of Second-Harmonic's Quantization Precision for Intensity Modulation Noise Suppressing in a Digital RFOG

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

Resonant Fiber Optic Gyro Based on A Sinusoidal Wave Modulation and Square Wave Demodulation Technique

How Laser Diode (LD) Intensity Modulation Induced by Current Tuning Affects the Performance of an Open-loop Resonator Fibre Optic Gyro (R-FOG) with Sinusoidal Wave Modulation

Suppressing Backscattering Noise of a Resonant Fiber Optic Gyroscope Using Coherent Detection.

Signal processing improvement of passive resonant fiber optic gyroscope using a reciprocal modulation-demodulation technique

Evaluation and Suppression of the Effect of Laser Frequency Noise on Resonant Fiber Optic Gyroscope

On a Closed-loop Resonator Fibre Optic Gyro (R-FOG) Employing a Semiconductor Laser

Resonator Fiber Optic Gyro Employing a Semiconductor Laser.