Abstract:Aiming at the demodulation signal compensation technique for intensity modulation noise suppressing in a digital RFOG, which is based on the detection of closed loop’s second-harmonic, the quantization precision for second-harmonic is discussed and optimized. By analyzing second-harmonic’s fluctuation under the intensity modulation noise equal to shot noise limited sensitivity, the expression for the required minimum quantization bits of second-harmonic signal is obtained. Based on this expression, numerical simulations are carried out to optimize the quantization bits in a digital RFOG in detail. Based on over-sampling technique, the stability of gyro output signal with different quantization bits and rotation rates is tested to verify the theoretically analyzed results. It is concluded that the minimum quantization bits of second-harmonic is related to the rotation rate and the ratio of second-harmonic’s maximum to minimum, and it gets larger as these two parameters are increased. Especially, the required minimum quantization bits for second-harmonic would generally exceed that supported only by hardware circuits, which leads to the adoption of over-sampling technique. And it is proven that the quantization precision improvement for second-harmonic, realized by the over-sampling technique, does work in improving the effect of intensity modulation noise suppressing.

Optimization of Second-Harmonic's Quantization Precision for Intensity Modulation Noise Suppressing in a Digital RFOG

An Open-Loop RFOG Based on Harmonic Division Technique to Suppress LD's Intensity Modulation Noise

A Harmonic Subtraction Technique to Suppress Intensity Modulation Induced Kerr Effect Drift in a Closed-Loop RFOG

Modulation Spectrum Analysis and Optimization for Closed-Loop RFOG under Dynamic Condition

An Open-Loop RFOG Based on 2nd/4th Harmonic Feedback Technique to Suppress Phase Modulation Index’s Drift

Influence of intensity noise on the resonant fiber optic gyroscope and restraining

Closed-loop RFOG Based on Square Wave Quadrature Demodulation

A Miniaturized Compact Open-Loop RFOG with Demodulation Signal Compensation Technique to Suppress Intensity Modulation Noise

A closed-loop RFOG based on digital serrodyne and sine modulations with two LiNbO3 phase modulators

Reduction of High-Frequency Laser Noise in Resonant Fiber Optic Gyroscope with a Phase-Modulated Feedback Loop

Optimization of Reciprocal Modulation Parameters in Resonant Fiber Optic Gyro

Noise Analysis and Parameter Optimization of Digital MEMS Accelerometer System

Reduction of relative intensity noise in a broadband source-driven RFOG using a high-frequency modulation technique

Laser frequency noise induced error in resonant fiber optic gyro due to an intermodulation effect.

Synchronous In-Phase and Quadrature Demodulation Technique for Resonant Micro-Optic Gyroscope.

Evaluation and Suppression of the Effect of Laser Frequency Noise on Resonant Fiber Optic Gyroscope

Optimization of the sinusoidal phase modulation technique in resonant fiber optic gyro

Improving the Scale Factor Thermal Stability of Resonant Fiber-Optic Gyroscopes by Tracking the Half-Wave Voltage of the Phase Modulator

Zero-deviation Effect in a Resonator Optic Gyro Caused by Nonideal Digital Ramp Phase Modulation

Reduction of optical Kerr-effect induced error in a resonant micro-optic gyro by light-intensity feedback technique.

Two-Bit Quantization for Harmonic Suppression