Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Technology for the Drag Reduction, Energy Saving and Output Increasing in Cyclone Separation

Numerical Simulation of the Effect of a Reducing Pressure Drop Stick in a Spiral Cyclone

Experimental Study and Analysis on Drag Reduction Mechanisms of Reducing Pressure Drop Stick in a Cyclone Separator

Effect of a Stick on the Flow Field in a Cyclone and the Pressure Drop Reduction Mechanism

Research on the Flow Field in the Exit Tube and the Mechanism of Pressure Drop Reduction in a Cyclone Separator

Effect of a Stick on the Gas Turbulence Structure in a Cyclone Separator

Gas Flow Analysis in Cyclone Separator with a Stick

Experimental Study of the Drag Reduction and Separation Efficiency for a New Hydrocyclone with a Reducing Pressure Drop Stick

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

EXPERIMENTAL STUDY OF THE EFFECT OF A REDUCING PRESSURE DROP STICK IN A CYCLONE BY PIV

Effect of a Reducing Pressure Drop Stick in the Flow Field of a Cyclone Separator

Experimental research on drag reduction by polymer additives in a turbulent pipe flow

Experimental investigation on separation characteristics of axial cyclone separator

Dynamics of Two-Dimensional Flow Around a Circular Cylinder with Flexible Filaments Attached

An Experimental Study of the Structural Optimization of Square Shaped Cyclone Separators

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Numerical analysis of a novel cascading gas-liquid cyclone separator

Experimental study on the separation performance of a novel oil–gas cyclone separator

Structural Drag Reduction in Taylor-Couette Flow

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Drag Reduction Technology of Water Flow on Microstructured Surfaces: A Novel Perspective from Vortex Distributions and Densities