Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Research on the Flow Field in the Exit Tube and the Mechanism of Pressure Drop Reduction in a Cyclone Separator

Numerical Simulation of the Effect of a Reducing Pressure Drop Stick in a Spiral Cyclone

Gas Flow Analysis in Cyclone Separator with a Stick

Effect of a Stick on the Gas Turbulence Structure in a Cyclone Separator

Effect of a Reducing Pressure Drop Stick in the Flow Field of a Cyclone Separator

Experimental Study and Analysis on Drag Reduction Mechanisms of Reducing Pressure Drop Stick in a Cyclone Separator

Effect of a Stick on the Flow Field in a Cyclone and the Pressure Drop Reduction Mechanism

Investigation on the character of 3D flow field and pressure drop

Technology for the Drag Reduction, Energy Saving and Output Increasing in Cyclone Separation

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

EXPERIMENTAL STUDY OF THE EFFECT OF A REDUCING PRESSURE DROP STICK IN A CYCLONE BY PIV

Experimental research of the flow field by using PDA in a new cyclone-type separator

FLOWPATTERN EFFECT ON THE SEPARATION PERFORMANCE IN CENTRIFUGAL SEPARAT OR

Numerical Simulation of the Influence of the Lengths of Exit Tubes on the Internal Flow Field of Cyclone Separators

Experimental Study of Pressure Drop of Single Phase in Cylindrical Cyclone

Experimental investigation on separation characteristics of axial cyclone separator

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

LES-DEM Investigation of the Gas-Solid Flow Characteristics in a Cyclone Separator

Experimental Investigation of Oil Film Flow and Droplets Behavior in the Annular Channel of a Cyclone Separator

A study on gas flow in spiral inlet cyclone separator

Investigation on the formation mechanism and flow characteristics of liquid carry-over in gas-liquid cyclone separator