Abstract:This study attempts to clarify the correlation between the structural parameters of vortex finders (diameter ratio and insertion depth) and the strong turbulent flow field and performance of cyclone separators. To elucidate the effects due to the overflow pipe diameter, insertion depth, and Reynolds number on the tangential velocity index (n) and separation efficiency, 0.3D, 0.4D, 0.5D, 0.6D, and 0.7D (where D is the diameter of the cyclone separator’s cylindrical section) were selected as the vortex finder diameter and insertion depth, which were studied using three methods: computational fluid dynamics (CFD) software Fluent, experiments, and artificial neural network simulations. With Fluent, the Reynolds stress model (RSM) of turbulence was adopted to describe transport equations, and the discrete phase model (DPM) for two-phase flow was used to calculate the efficiency and separate particles at different inlet velocities. Experiments were conducted to measure the operational pressure drop and separation efficiency of the system; subsequently, the results were used to validate the CFD calculation results. Finally, a 5–5-1 three-layer artificial neural network was established based on 336 sets of data for values of n obtained from numerical simulations. In addition, a backpropagation (BP) artificial neural network model was employed to predict the correlation between the structural and operational parameters of the cyclone separator and n values. The obtained results indicate that the BP artificial neural network can accurately predict the distribution of n values within the flow field of the cyclone. Increasing the diameter of the vortex finder with the same inlet velocity can reduce the total pressure drop due to the cyclone, thereby reducing the kinetic energy loss and improving the separation efficiency of fine particles. Increasing the insertion depth of the vortex finder leads to an increase in the values of n. Considering the stability of the flow field structure and energy dissipation, an S/D value between 0.5 and 0.6 is preferred.

Effect of a Reducing Pressure Drop Stick in the Flow Field of a Cyclone Separator

Effect of a Stick on the Flow Field in a Cyclone and the Pressure Drop Reduction Mechanism

Experimental Study and Analysis on Drag Reduction Mechanisms of Reducing Pressure Drop Stick in a Cyclone Separator

Numerical Simulation of the Effect of a Reducing Pressure Drop Stick in a Spiral Cyclone

EXPERIMENTAL STUDY OF THE EFFECT OF A REDUCING PRESSURE DROP STICK IN A CYCLONE BY PIV

Experimental Study of the Drag Reduction and Separation Efficiency for a New Hydrocyclone with a Reducing Pressure Drop Stick

Research on the Flow Field in the Exit Tube and the Mechanism of Pressure Drop Reduction in a Cyclone Separator

Gas Flow Analysis in Cyclone Separator with a Stick

Numerical Study of Gas Phase Flow in Cyclones with the Repds

Effect of a Stick on the Gas Turbulence Structure in a Cyclone Separator

CFD study on the performance of reducing pressure drop holes in cyclone separator

Investigation on the character of 3D flow field and pressure drop

Technology for the Drag Reduction, Energy Saving and Output Increasing in Cyclone Separation

Numerical Study on Flow Around Four Square-Arranged Cylinders at Low Reynolds Numbers

Experimental research on the flow characteristics and vortex shedding in the flow around a circular cylinder

Experimental research on drag reduction by polymer additives in a turbulent pipe flow

Performance experiments and pressure drop prediction modelling of an energy-saving cyclone separator

Simulation and experimental study of effect of vortex finder structural parameters on cyclone separator performance

Effect of back pressure on the separation performance of a hydrocyclone

FLOWPATTERN EFFECT ON THE SEPARATION PERFORMANCE IN CENTRIFUGAL SEPARAT OR

Simulation Investigation on the Flow and Mixing in Ducts of the Rotary Energy Recovery Device