Abstract:The hybrid process of selective noncatalytic reduction (SNCR) followed by selective catalytic reduction (SCR) is an up-to-date nitrogen oxides control technique and can achieve a high efficiency (60%-95%) with moderate cost. The SNCR/SCR hybridization was investigated through experimentation on a 100MW, coal-fired utility boiler in China. The baseline nitrogen oxides emission of the hybrid urea-based SNCR/SCR system was 170 ppm at 6% O(2) controlled by coal reburning technology. The hybrid SNCR/SCR system including only 89 m(3) catalysts could control NO emission under 25 ppm with ammonia slip <4ppm at 300-430 tons/h of boiler load. Total NO reduction efficiency was generally about 85% and could be beyond 90%, in which SCR's efficiency was 50%-70% individually and SNCRs was about 60%-75%. NO emission decreased from about 65 to 15 ppm when the flow rate of 35% urea solution increased from 0.15 to 0.47 tons/h. At higher boiler load, more urea solution had to be injected and higher layer of the agent injectors had to come into operation to hit the same emission target. The superheated steam was injected with high speed into flue gases at the inlet of reversing chamber and it was effective on enhancing both the total quantities and the distribution of SNCR's ammonia residue, which was used as reducing agent of SCR. In general there was more NH(3) where there was less NO at the inlet of catalysts and NO distribution was contrary to NH(3) distribution in some way. NO and NH(3) distribution at the outlet of catalysts was almost even compared with the inlet distribution. Average NH(3) slip at the outlet increased with NH(3) at the inlet and could be controlled below 4 ppm at 6% O(2) in any case. The difference between average NH(3) at the inlet and the outlet was smaller several times than the reduced NO by SCR catalysts. Some isocyanic acid (HNCO) as the product of urea solution thermohydrolysis might exist in the flue gas and it was hydrolyzed to NH(3) quickly on SCR catalysts, which then reduced NO on the surface of SCR catalysts.

Analysis on operation cost of SCR system in coal-fired power plant

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Model Predictive Control Case Study: Selective Catalytic Reduction (scr) System in Coal-Fired Power Plant

Advanced Exergoenvironmental Evaluation for a Coal-Fired Power Plant of Near-Zero Air Pollutant Emission

Optimization on plant-level AGC coal consumption curve based on operation mode of pulverizing systems

Enhancement of SCR denitrification control strategy considering fluegas temperature fluctuation: Fundamental principle and performance evaluation

Cost estimate of the multi-pollutant abatement in coal-fired power sector in China

Economic and Carbon Emission Analysis of Two Typical Denitrification Systems for Sintering Process in the Iron and Steel Industry

Energy Consumption and Energy-Saving Potential Analysis of Pollutant Abatement Systems in a 1000-MW Coal-Fired Power Plant.

Change of Ammonia Escape Rate and SO3 Conversion Rate of SCR Denitration in Full Load Range

Effect of Selective Catalytic Reduction (scr) on Fine Particle Emission from Two Coal-Fired Power Plants in China

Evaluation on Operation State and Stability for Denitrification of Ultra Low Emission

Design and Operational Considerations for Selective Catalytic Reduction Technologies at Coal-Fired Boilers

Study on Optimization Experiment of SCR Denitrification Technologies in a Coal-fired Power Plant

Cost-Efficient Nitrogen Oxides Control by a Hybrid Selective Noncatalytic Reduction and Selective Catalytic Reduction System on a Utility Boiler

Operation optimization and costs analysis of the wet desulfurization system in an ultra‐supercritical coal‐fired power plants

Estimating the Environmental Efficiency and Marginal CO2 Abatement Cost of Coal-Fired Power Plants in China

Technology Development and Cost Analysis of Multiple Pollutant Abatement for Ultra-Low Emission Coal-Fired Power Plants in China

Investigating the Optimization Design of Internal Flow Fields Using a Selective Catalytic Reduction Device and Computational Fluid Dynamics

Evaluation system for testing performance of selective catalytic reduction (SCR) denitration catalyst

The Integrated System Optimization Based on the Boiler Combustion and Denitration with Denitration Operating Cost Consideration.