Abstract:In order to meet the growing industrial demand of high quality and high efficiency machining, long cutters with larger axial depth of cut are extensively implemented in peripheral milling of deep pockets, grooves, and thin-wall parts. However, due to their high flexibilities, chatter easily occurs during the machining process. It has been demonstrated that milling cutters with variable pitch and/or variable helix angles can mitigate the chatter, which are gaining increasingly important applications. Although this kind of cutters have been studied in some detail in previous research, few studies have focused on the interaction dynamics complicated by actual cutter runout in long tool-part contact zone. This paper systematically studies the dynamics and stability of variable-pitch/helix milling system with long end cutters. The cutters are divided into a series of axial disks, and each axial disk includes several cutting elements which are equal to the number of teeth. Variations of pitch and helix angles, cutter run-outs including radial offset and axial tilt, and mode shapes with the cross terms in the orthogonal direction, are assigned to these cutting elements. The system, involving multiple regenerative delays as well as the axially varying dynamics, is formulated as a matrix form of time-periodic delay differential equation with multi-modal dynamic parameters. An updated cross-axis and cross-point modal testing method is then proposed to obtain the dynamic parameters, which can effectively avoid multiple hits when impacting the cutter with hammer. The stability lobes are predicted in state space by developing an improved semi-discretization method, by which the pitch variations and actual runout effects on stability are investigated. It is shown that the stability lobes differ significantly when the combined effects of cross-axis and cross-point FRFs and actual cutter runout are considered. A series of cutting experiments is conducted to demonstrate the proposed model and method. Results show that these lobes well agree with the experimental results.

Stability analysis and experimental research for three-dimensional dither in processing of high speed milling

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Stability Analysis of Milling Based on the Barycentric Rational Interpolation Differential Quadrature Method

Stability Analysis for Milling Process with Variable Pitch and Variable Helix Tools by High-Order Full-Discretization Methods

Stability analysis of thin-walled parts end milling considering cutting depth regeneration effect

Stability analysis of high speed milling process considering internal damping of composite cutter bar and gyroscopic effect in rotating coordinates

Stability analysis for milling system with variable pitch cutters under variable speed

Modelling of the stability of variable helix end mills

Modeling of variable-pitch/helix milling system considering axially varying dynamics with cutter runout offset and tilt effects

Effects of Spindle Speed-Dependent Dynamic Characteristics of Ball Bearing and Multi-Modes on the Stability of Milling Processes

Chatter stability analysis of variable speed milling with helix angled cutters

Regenerative Effects of Orthogonal Chip Dimensions on Turning Stability of Thin-Wall Workpiece-Tool Coupled Dynamics

Chatter suppression analysis for variable pitch cutter in milling

An efficient and precise stability analysis method for milling process

Effects of Helix Angle and Multi-Mode on the Milling Stability Prediction Using Full-Discretization Method

Three Dimensional Finite Element Simulation and Analysis of Residual Stress in Milling

Research on milling stability of thin-walled parts based on improved multi-frequency solution

Modeling of Spindle-process Interaction and Cutting Parameters Optimization in High-speed Milling

Prediction of Chatter Stability in High Speed Milling Using the Numerical Differentiation Method

Chatter Stability Prediction of Ball-End Milling Considering Multi-Mode Regenerations

Milling stability analysis with simultaneously considering the structural mode coupling effect and regenerative effect