Abstract:Despite recent advances and improvements in modeling and prediction of the dynamics of the machining process, an efficient machining process is limited due to chatter and instability of machining system. In fact, the machining system contains various kinds of joints, which cause difficulties in dynamics modeling, simulation and prediction. Moreover, the flexible support system results in large deformation and violent vibration of the workpiece when machining, and the thin-walled workpiece easily gives rise to the chatter of the machining system. Therefore, the dynamics of the flexible support system was considered to calculate stability lobe diagram in the modeling of milling process. The whole machining system was regarded as a closed loop composed by the machine tool structures, support, workpiece and machining process. In this paper, the receptance coupling (RC) method was introduced to predict the dynamics of the closed machining system. A milling process was taken for example to predict the chatter limitations using the dynamics of closed model. The mathematical model of the machining system (machine tool structures, spindle, holder and tool), together with the details of joint contacts, was given based on the RC method. The RC model was used to obtain the dynamics of the system, while receptance of the tool point was coupled. Based on the coupling model of the machining system, the depth limitations under different speeds were estimated for the technology parameter optimization in milling process. The response was considered to be the sum of the cutting point and the support system. The flexibility of the support system was considered to be the feedback of the cutting stiffness. By this means, the traditional model was modified to calculate the stability lobe diagram based on the dynamics of the spindle and support system. Furthermore, the milling experiment was carried out to verify the prediction results, and the dominant natural frequencies of receptance at tool point were obtained by modal testing to define the stability lobe diagram. It was found that the chatter results matched well with the stability lobes. It was concluded that the support system with poor stiffness might cause violent chatter especially when the workpiece was thin-walled. The cutting depth limitations of the flexible support system were lower than that of the rigid one. Moreover, this closed model of the machining system is appropriate for the chatter prediction of the flexible support system or thin-walled workpiece, so it is helpful for a better parameter optimization.

Regenerative Effects of Orthogonal Chip Dimensions on Turning Stability of Thin-Wall Workpiece-Tool Coupled Dynamics

Stability analysis of thin-walled parts end milling considering cutting depth regeneration effect

Modelling of Regenerative and Frictional Cutting Dynamics

Multiple Regenerative Effects in Cutting Process and Nonlinear Oscillations

Milling Stability Prediction for Flexible Workpiece Using Dynamics of Coupled Machining System

Stability Prediction of Milling Process with Closed Machining System Dynamics with Flexible Thin-Walled Workpiece

A novel approach of stability and topography prediction in five-axis ball-end milling process through workpiece-edge-coupling

Modeling of variable-pitch/helix milling system considering axially varying dynamics with cutter runout offset and tilt effects

Dynamics and Stability of Milling Thin Walled Pocket Structure

Effect of state-dependent time delay on dynamics of trimming of thin-walled structures

Cutting mechanics and efficiency of forward and reverse multidirectional turning

Dynamics and Stability Prediction of Five-Axis Flat-End Milling

Investigation of Dynamic Behavior and Process Stability at Turning of Thin-Walled Tubular Workpieces Made of 42CrMo4 Steel Alloy

Milling stability analysis with simultaneously considering the structural mode coupling effect and regenerative effect

The Periodical Fluctuation of Residual Stress in Hard Turned Surface and Its Relationship with Chip Formation

Stability analysis of high speed milling process considering internal damping of composite cutter bar and gyroscopic effect in rotating coordinates

Investigation of Machining Stability Considering Thermal and Rotation Effect: Effectiveness of Impact Excitation for a Rotating Spindle

Research on the influence of robot structural mode on regenerative chatter in milling and analysis of stability boundary improvement domain

Investigation on dynamic tool deflection and runout-dependent analysis of the micro-milling process

Stability analysis of milling processes with varying workpiece dynamics

Stability Analysis of Pocket Machining with the Spiral Tool Path Using the Discontinuous Galerkin Method