Abstract:A simple and general Equivalent Dynamic Stiffness Mapping technique is proposed for identifying the parameters or the mathematical model of a nonlinear structural element with steady-state primary harmonic frequency response functions (FRFs). The Equivalent Dynamic Stiffness is defined as the complex ratio between the internal force and the displacement response of unknown element. Obtained with the test data of responses׳ frequencies and amplitudes, the real and imaginary part of Equivalent Dynamic Stiffness are plotted as discrete points in a three dimensional space over the displacement amplitude and the frequency, which are called the real and the imaginary Equivalent Dynamic Stiffness map, respectively. These points will form a repeatable surface as the Equivalent Dynamic stiffness is only a function of the corresponding data as derived in the paper. The mathematical model of the unknown element can then be obtained by surface-fitting these points with special functions selected by priori knowledge of the nonlinear type or with ordinary polynomials if the type of nonlinearity is not pre-known. An important merit of this technique is its capability of dealing with strong nonlinearities owning complicated frequency response behaviors such as jumps and breaks in resonance curves. In addition, this technique could also greatly simplify the test procedure. Besides there is no need to pre-identify the underlying linear parameters, the method uses the measured data of excitation forces and responses without requiring a strict control of the excitation force during the test. The proposed technique is demonstrated and validated with four classical single-degree-of-freedom (SDOF) numerical examples and one experimental example. An application of this technique for identification of nonlinearity from multiple-degree-of-freedom (MDOF) systems is also illustrated.

Damping identification for stiffness-nonlinearity structures

Damping Parameter Identification Of Large Span Cable-Stayed Bridges

Identification of Aerodynamic Damping of Cable Domes

INVESTIGATION OF DAMPING MATRICES ACCURATE ESTIMATION OF CABLE-STAYED BRIDGES BASED ON NON-PROPORTIONAL DAMPING

Modal Testing and Detection of Pretension Deviation in a Cable Dome Structure

Damping identification using weighted fitting of Frequency-response-function (WFF) method

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

Identification of Instantaneous Frequency and Damping From Transient Decay Data

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Structural Damping Ratio Identification through Iterative Frequency Domain Decomposition

Parameter identification for stiffness and damping of active magnetic bearing in flexible rotor system

Parameter identification of non-classically damped mechanical structures in time domain

Research on the Simulation Method for Equivalent Stiffness of Bolted Connection Thin Plate Structures

Modal parameter identification for engineering structures based on HHT method

Non-Linear System Identification Using Frequency Domain Measurement Data

Equivalent Dynamic Stiffness Mapping Technique for Identifying Nonlinear Structural Elements from Frequency Response Functions

Dynamic Stiffness Identification of Bolted Joints

Various damper forces and dynamic excitation nonparametric identification with a double Chebyshev polynomial using limited fused measurements

Research on Nonlinear Vibration Test and Parameter Identification of Aluminum Honeycomb Sandwich Plate in Satellite Structure

Comparison of Nonlinear System Identification Methods for Free Decay Measurements with Application to Jointed Structures

Quasi-static testing based structural modal parameter estimation