Abstract:Modal parameters are inherent characteristics of civil structures. Due to the effect of environmental factors and ambient loads, the physical and modal characteristics of a structure tend to change over time. Therefore, the effective identification of time-varying modal parameters has become an essential topic. In this study, an instantaneous modal identification method based on an adaptive chirp mode decomposition (ACMD) technique was proposed. The ACMD technique is highly adaptable and can accurately estimate the instantaneous frequencies of a structure. However, it is important to highlight that an initial frequency value must be selected beforehand in ACMD. If the initial frequency is set incorrectly, the resulting instantaneous frequencies may lack accuracy. To address the aforementioned problem, the Welch power spectrum was initially developed to extract a high-resolution time–frequency distribution from the measured signals. Subsequently, the time–frequency ridge was identified based on the maximum energy position in the time–frequency distribution plot, with the frequencies associated with the time–frequency ridge serving as the initial frequencies. Based on the initial frequencies, the measured signals with multiple degrees of freedom could be decomposed into individual time-varying components with a single degree of freedom. Following that, the instantaneous frequencies of each time-varying component could be calculated directly. Subsequently, a sliding window principal component analysis (PCA) method was introduced to derive instantaneous mode shapes. Finally, vibration data collected under various operational scenarios were used to validate the proposed method. The results demonstrated the effective identification of time-varying modal parameters in real-world civil structures, without missing modes.

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

STUDY ON THE AUTOCORRELATION-BASED VIBRATION SIGNAL EMD DECOMPOSITION METHOD IN ROTATING MACHINERY

Energy-Based Stop Condition of Empirical Mode Decomposition of Vibration Signal

The Application of Energy Operator Demodulation Approach Based on Emd in Mechanical System Identification

Vibration Mode Extraction Method Based on the Characteristics of White Noise

Damping identification using weighted fitting of Frequency-response-function (WFF) method

MODAL DAMPING PARAMETER IDENTIFICATION METHOD BASED ON IMPROVED VMD AND ENVELOPE FITTING AND ITS APPLICATION

Structural dynamic and aerodynamic parameters identification for a tall building with full-scale measurements

Research on an Estimate Method of Torsional Vibration for Rotating Machinery Based on HHT Analysis

Modal Identification of Multi-Degree-of-freedom Structures Based on Intrinsic Chirp Component Decomposition Method

Parameter identification for stiffness and damping of active magnetic bearing in flexible rotor system

Structural Damping Ratio Identification through Iterative Frequency Domain Decomposition

A Novel Method of Pure Output Modal Identification Based on Multivariate Variational Mode Decomposition

A Mechanical Fault Detection Strategy Based on the Doubly Iterative Empirical Mode Decomposition

Discrete analytical mode decomposition with automatic bisecting frequency selection for structural dynamic response analysis and modal identification

An Adaptive Chirp Mode Decomposition-Based Method for Modal Identification of Time-Varying Structures

Experimental Study of Modal Parameter Identification in a Simulated Ambient-Excited Structure

Modal parameter identification for engineering structures based on HHT method

Identification of damping characteristics of transmission towers using EEMD

Identification of forced time-varying systems via intrinsic chirp component decomposition