Abstract:Modal parameters are inherent characteristics of civil structures. Due to the effect of environmental factors and ambient loads, the physical and modal characteristics of a structure tend to change over time. Therefore, the effective identification of time-varying modal parameters has become an essential topic. In this study, an instantaneous modal identification method based on an adaptive chirp mode decomposition (ACMD) technique was proposed. The ACMD technique is highly adaptable and can accurately estimate the instantaneous frequencies of a structure. However, it is important to highlight that an initial frequency value must be selected beforehand in ACMD. If the initial frequency is set incorrectly, the resulting instantaneous frequencies may lack accuracy. To address the aforementioned problem, the Welch power spectrum was initially developed to extract a high-resolution time–frequency distribution from the measured signals. Subsequently, the time–frequency ridge was identified based on the maximum energy position in the time–frequency distribution plot, with the frequencies associated with the time–frequency ridge serving as the initial frequencies. Based on the initial frequencies, the measured signals with multiple degrees of freedom could be decomposed into individual time-varying components with a single degree of freedom. Following that, the instantaneous frequencies of each time-varying component could be calculated directly. Subsequently, a sliding window principal component analysis (PCA) method was introduced to derive instantaneous mode shapes. Finally, vibration data collected under various operational scenarios were used to validate the proposed method. The results demonstrated the effective identification of time-varying modal parameters in real-world civil structures, without missing modes.

Experimental Study of Modal Parameter Identification in a Simulated Ambient-Excited Structure

A Multi-Task Learning-Based Automatic Blind Identification Procedure for Operational Modal Analysis

DEEP LEARNING-BASED AUTOMATIC BLIND IDENTIFICATION PROCEDURE FOR STRUCTURAL MODAL IDENTIFICATION

Structural dynamic and aerodynamic parameters identification for a tall building with full-scale measurements

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

Operational modal parameter identification of structures for non-stationary ambient excitation

Structural modal identification and MCMC-based model updating by a Bayesian approach

Modal Parameter Identification of Linear Time Invariant System under Non-stationary Ambient Excitation

Parameters Identification of Linear Structures Undergoing Ambient Excitation Using Mode Decomposition

Modal Parameter Identification of a Bridge Under Ambient Excitation

MODAL PARAMETER IDENTIFICATION OF EXPERIMENTAL DATA BASED ON DYNAMIC ENVIRONMENT

Quasi-static testing based structural modal parameter estimation

Model-free Identification of Multiple Periodic Excitations and Detection of Structural Anomaly Using Noisy Response Measurements

Modal Parameter Identification of Structure under Base Excitation Using Vibration Test Data

Modal Parameter Discrimination of Structural Mode based on Vibration Test

An Adaptive Chirp Mode Decomposition-Based Method for Modal Identification of Time-Varying Structures

Modal parameter identification of tall buildings based on variational mode decomposition and energy separation

Improved Automatic Operational Modal Analysis Method and Application to Large-Scale Bridges

Modal parameter extraction from improved principal component analysis and structural state identification

Modal Parameter Identification Based on Multi-Axis Vibration Environment Test

Experimental Study of the Operational Modal Analysis of Latticed Domes