Abstract:The workpiece dynamics are an important factor in the planning of machining strategy. Usually, the structural dynamic parameters of workpiece are obtained by experimental modal analysis (EMA). However, the dynamics of thin-walled workpiece are varying due to material removal and tool-workpiece coupling. Operational modal analysis (OMA) provides a route to estimate the structural dynamic parameters during operation, but the input excitation of milling system is mainly periodic milling force, which violates the premise of OMA. In this paper, an output-only modal identification method for the dynamic parameters of thin-walled workpiece is proposed. The milling force is analyzed and the analysis results show the milling force contains white noise for OMA. However, strong harmonic components in milling force seriously interfere the identification of dynamic parameters. To remove the harmonic components in response signal, a revised least-squares (LS) method is proposed to fit harmonics with multiple fundamental frequencies. After the harmonic removal, OMA is conducted in frequency domain using the poly-reference least squares complex frequency (p-LSCF) method based on positive power spectral density (PSD). To verify the feasibility of the proposed method, the simulation case is conducted by exciting a 3-degree of freedom structure using measured milling force signal, and the results show a good agreement with the theoretical values both in frequencies and damping ratios. Furthermore, a series of milling tests under different cutting parameters are conducted on a thin-walled workpiece, where thin-film sensors are adopted to measure the structural response. The results show the method can be successfully applied to extract the workpiece dynamic parameters. Compared with results of EMA, the structural frequencies increase slightly, while the damping ratios show a large promotion due to the process damping.

The Application of Energy Operator Demodulation Approach Based on Emd in Mechanical System Identification

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

Wavelet-based Electromechanical Mode Shape Online Identification from Ambient Data

DEEP LEARNING-BASED AUTOMATIC BLIND IDENTIFICATION PROCEDURE FOR STRUCTURAL MODAL IDENTIFICATION

A REDUCED ORDER MODELING OF NONLINEAR ELECTROSTATIC-MECHANICAL SYSTEMS BASED ON THE ENERGY IDENTIFICATION APPROACH

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

Damping identification using weighted fitting of Frequency-response-function (WFF) method

MODAL DAMPING PARAMETER IDENTIFICATION METHOD BASED ON IMPROVED VMD AND ENVELOPE FITTING AND ITS APPLICATION

THE APPLICATION OF THE EXTENDED EIGENSYSTEM REALIZATION ALGORITHM FOR STRUCTURAL MODAL PARAMETER IDENTIFICATION

Modal Identification of Multi-Degree-of-freedom Structures Based on Intrinsic Chirp Component Decomposition Method

Operational modal analysis based dynamic parameters identification in milling of thin-walled workpiece

Modal parameter identification of tall buildings based on variational mode decomposition and energy separation

Synthetical Modal Parameters Identification Method of Damped Oscillation Signals in Power System

Closed-Loop Dynamic Parameter Identification of Robot Manipulators Using Modified Fourier Series

Parameter identification for stiffness and damping of active magnetic bearing in flexible rotor system

Oscillation Mode Identification Method of Renewable Energy Stations Based on Dynamic Mode Decomposition with Control

Various damper forces and dynamic excitation nonparametric identification with a double Chebyshev polynomial using limited fused measurements

Instantaneous Modal Parameter Identification of Linear Time-Varying Systems Based on Chirplet Adaptive Decomposition

Identification of Instantaneous Frequency and Damping From Transient Decay Data

Bayesian FFT Modal Identification for Multi-setup Experimental Modal Analysis

A Data-Driven, Energy-based Approach for Identifying Equations of Motion in Vibrating Structures Directly from Measurements