Abstract:In order to improve the effective acquisition speed for mode shape information in the dynamic characteristics of inter-area oscillation,we put forward a new algorithm for rapid estimating the inter-area oscillation mode shapes and corresponding modes using correlation analysis.Firstly,the algorithm extracts a weak damping component which is associated with objective mode from each tie-line active power signal,and the signal comes from WAMS through a low-pass or band-pass filter which is designed by a priori modal knowledge obtained from off-line calculation.Then,the self-correlation and cross-correlation coefficients resulted from correlation analysis of these time-domain signals are used to determine an inter-area mode shape of tie-line power deviation and equivalent speed deviation which always corresponds to a mode.Finally,the results about inter-area oscillation features are checked with the modal form from off-line calculation in order to confirm the dominant mode and its mode shape in current state.Two pairs of stationary and non-stationary synthetic signals are utilized to verify the applicability of this method.The case studies have been carried out on a 4-area 9-bus system and a planning case in East China Power Grid.The results show that the proposed algorithm is efficient and effective,indicating the potential practicability for WAMS of bulk power system.

Wavelet-based Electromechanical Mode Shape Online Identification from Ambient Data

Detecting Oscillations Via Adaptive Chirp Mode Decomposition.

Automatic Detection of Nonstationary Multiple Oscillations by an Improved Wavelet Packet Transform

Vibration Mode Extraction Method Based on the Characteristics of White Noise

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

New Algorithm for Mode Shape Estimation Based on Ambient Signals Considering Model Order Selection.

Improvement of Electromechanical Mode Identification from Ambient Data with Stochastic Subspace Method

Estimating The Electromechanical Oscillation Characteristics Of Power System Based On Measured Ambient Data Utilizing Stochastic Subspace Method

A Power Spectrum Density Based Signal Selection Approach for Electromechanical Mode Estimation

Identification of Mode Shape Based on Ambient Signals and ARMA-P Method

Applicability Analysis of Algorithms for Electromechanical Mode Identification Based on Measured Data

Estimation of the electromechanical characteristics of power systems based on a revised stochastic subspace method and the stabilization diagram

Mode Shape Estimation and Mode Identification for Inter-Area Oscillations Utilizing Correlation Analysis Techniques

Oscillation mode analysis for multi-mode coupling power systems with high renewables penetration using improved blind source separation

Oscillation Mode Identification Method of Renewable Energy Stations Based on Dynamic Mode Decomposition with Control

Algorithm for Inter-area Oscillation Mode Shape Estimation Using Correlation Analysis

Power System Low Frequency Oscillation Monitoring and Analysis Based on Multi-Signal Online Identification

Empirical Wavelet Transform Based Method for Identification and Analysis of Sub-synchronous Oscillation Modes Using PMU Data

Model-free Identification of Multiple Periodic Excitations and Detection of Structural Anomaly Using Noisy Response Measurements

Analysis of short time power quality disturbances based on statistic feature vector symbolic and ensemble empirical mode decomposition

General formulation of transfer function identification for power system based on WAMS