Abstract:In order to improve the effective acquisition speed for mode shape information in the dynamic characteristics of inter-area oscillation,we put forward a new algorithm for rapid estimating the inter-area oscillation mode shapes and corresponding modes using correlation analysis.Firstly,the algorithm extracts a weak damping component which is associated with objective mode from each tie-line active power signal,and the signal comes from WAMS through a low-pass or band-pass filter which is designed by a priori modal knowledge obtained from off-line calculation.Then,the self-correlation and cross-correlation coefficients resulted from correlation analysis of these time-domain signals are used to determine an inter-area mode shape of tie-line power deviation and equivalent speed deviation which always corresponds to a mode.Finally,the results about inter-area oscillation features are checked with the modal form from off-line calculation in order to confirm the dominant mode and its mode shape in current state.Two pairs of stationary and non-stationary synthetic signals are utilized to verify the applicability of this method.The case studies have been carried out on a 4-area 9-bus system and a planning case in East China Power Grid.The results show that the proposed algorithm is efficient and effective,indicating the potential practicability for WAMS of bulk power system.

Identification of Mode Shape Based on Ambient Signals and ARMA-P Method

Wavelet-based Electromechanical Mode Shape Online Identification from Ambient Data

Research on identification algorithms applicability for power grid damping online monitoring

Ambient signals based power system oscillation modes identification considering model order selection

Identification of Oscillation Phase Relationship among Nodes Based on Wide Area Measured Ambient Signals

Wide Area Monitoring and Analysis of Henan Power System Dynamic Performance

A Real-Time Monitoring Method for Power System Steady State Angle Stability Based on Wams

New Algorithm for Mode Shape Estimation Based on Ambient Signals Considering Model Order Selection.

Automatic Post-disturbance Simulation Based Method for Power System Load Modeling

Analysis of Frequency Oscillation Caused by AGC in Hydro-Dominant Power Grids Using Piecewise Linearization Method

Detecting Oscillations Via Adaptive Chirp Mode Decomposition.

Simulation Analysis on Influencing Factors on Low Frequency Oscillation of Regional Power Grids of Small Hydropower Stations of Yunnan Power Grid

Estimating The Electromechanical Oscillation Characteristics Of Power System Based On Measured Ambient Data Utilizing Stochastic Subspace Method

Applicability Analysis of Algorithms for Electromechanical Mode Identification Based on Measured Data

Oscillation Mode Identification Method of Renewable Energy Stations Based on Dynamic Mode Decomposition with Control

Common Mode Frequency Analysis Modeling and Quantification Method for Power System with High Penetration of Renewable Energy Generation

Improvement of Electromechanical Mode Identification from Ambient Data with Stochastic Subspace Method

Low-frequency oscillation parameter identification based on the random response theory

Algorithm for Inter-area Oscillation Mode Shape Estimation Using Correlation Analysis

Analysis Method for Low Frequency Oscillation in East China Power Grid Based on Power System Simulation Software PSS/E

Mode Shape Estimation and Mode Identification for Inter-Area Oscillations Utilizing Correlation Analysis Techniques