Abstract:The major problem in current online diagnosis and analysis for power system oscillation is how to locate the oscillation source with the limited data of wide area measurement system (WAMS) quickly and correctly. This paper put forward a practical solution of constructing the cutsets and calculating the oscillation energy based on WAMS data. The concept and calculation method of cutset oscillation energy were defined at first. The cutsets of different levels of network were constructed and the oscillation energy was calculated with the dynamic information of WAMS on key lines. According to the direction of the oscillation energy flow, the cutset with positive flow can be identified as oscillation source. At last, the cutset energy method was proved to be effective by power system simulation and the Three Gorges The major problem in current online diagnosis and analysis for power system oscillation is how to locate the oscillation source with the limited data of wide area measurement system (WAMS) quickly and correctly. This paper put forward a practical solution of constructing the cutsets and calculating the oscillation energy based on WAMS data. The concept and calculation method of cutset oscillation energy were defined at first. The cutsets of different levels of network were constructed and the oscillation energy was calculated with the dynamic information of WAMS on key lines. According to the direction of the oscillation energy flow, the cutset with positive flow can be identified as oscillation source. At last, the cutset energy method was proved to be effective by power system simulation and the Three Gorges Power Plant oscillation curve analysis. The analysis cases show that the cutset energy method can reveal the oscillation characteristics intuitively and locate the oscillation source quickly, which can make full use of WAMS data and do not depend on accurate parameters.

Wide Area Monitoring and Analysis of Henan Power System Dynamic Performance

A Real-Time Monitoring Method for Power System Steady State Angle Stability Based on Wams

The Power Angle and Phase Measurement Units Based Wide Area Measurement System and Its Application

Automatic Post-disturbance Simulation Based Method for Power System Load Modeling

Electric Load Modeling for Wide Area Power Systems

Online Damping Monitoring Approach Based on Disturbances of Traction Load and Its Application

Architecture and Key Technologies of Wide-area Collaborative Monitoring System for Power Grid Wide-frequency Oscillation

Load Modeling for Wide Area Power System

WIDE-AREA REAL TIME DYNAMIC SECURITY MONITORING SYSTEM OF NORTH CHINA POWER GRID

Wide-area Monitoring and Analysis of Wide-band Oscillation in New-type Power Systems

Power System Stability Control Based on Wide Area Measurement System

Dynamic Characteristic Analysis of Power System Interarea Oscillations Using HHT

Power System Low Frequency Oscillation Monitoring and Analysis Based on Multi-Signal Online Identification

Overview of Power System Stability Analysis and Wide-area Control in Consideration of Time Delay

Development of the On-line Voltage Stability Monitoring System Based on Wide Area Measurement System

Power System Oscillation Analysis and Oscillation Source Location Based on WAMS Part 1:Method of Cutset Energy

Wide-area measurement system based power load modeling

Fluctuation Magnitude Calculation and Oscillation Probability Analysis of Tie-Line Active Power in Interconnected Power System

Stability Analyze of Wide Area Measurement System with Limited Communication

An Improved WAMS Framework for Multi-modal Oscillation Detection in a Power Electronics Dominated Power System

Research of on-line analysis algorithms of low-frequency oscillation in power system base on WAMS