Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Simulation on the Performance of Adiabatic Capillary Tubes With R410A Refrigerant

Numerical Simulation and Experimental Study of Capillary Tubes

Analysis on the Adiabatic Flow of R407C in Capillary Tube

Numerical simulation of condensation heat transfer and pressure-drop performance of R22 and R407C in horizontal microfin tube

NUMERICAL CALCULATION OF FLOW IN ADIABATIC CAPILLARY TUBE OF ALTERNATIVE REFRIGERANTS

Research on Adiabatic Capillary Tubes′ Correlation of R134a Unit Air-conditioning

STUDY ON FLOW BEHAVIOR OF R22 ALTERNATIVE REFRIGERANT IN CAPILLARY TUBE

The simulation and analysis of fin-tube evaporator for air-conditioning

Fast Calculation Method for Modeling Non-adiabatic Capillary Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Numerical Simulation of Condensation for R410A at Varying Saturation Temperatures in Mini/micro Tubes

A generalized correlation for the characteristics of adiabatic capillary tubes

One-order Integral Model of Refrigerants Flowing Through Adiabatic Capillary Tubes

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

Numerical modeling of refrigerants flowing through short tube orifices

Comparison Between Model-established Simulation and Experiment for Evaporators

Simulation Study on Fin-tube Condenser

General integral model of capillary tubes

Mass Flow Distribution of Refrigerant in the Evaporator and Design Method of the Distribute Tube

Numerical Simulation of Condensation for R410a in Horizontal Round and Flattened Minichannels

Influence of refrigerant circuitry on performance of R410A condensers