Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Numerical Simulation of Condensation for R410A at Varying Saturation Temperatures in Mini/micro Tubes

Numerical Simulation and Experimental Study of Capillary Tubes

Numerical Simulation of Condensation for R410a in Horizontal Round and Flattened Minichannels

Numerical Simulation of R410A Condensation in Horizontal Microfin Tubes

Numerical study on heat transfer and pressure drop characteristics of R410A condensation in horizontal circular mini/micro tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels

Convective condensation of R410A in micro-fin tubes

Experimental investigation of condensation heat transfer and pressure drop of R22, R410A and R407C in mini-tubes

Condensation Pressure Drop and Heat Transfer in 5-Mm-od Micro-Fin Tubes

Numerical simulation of condensation in horizontal circular and square minichannels using R134a

A Numerical Investigation of Convective Condensation in Micro-Fin Tubes of Different Geometries

Condensation heat transfer and pressure drop characteristics inside smooth and enhanced tubes with R410A and R32

Convective Condensation Inside Horizontal Smooth and Microfin Tubes

Heat Transfer and Pressure Drop Characteristics of Condensation for R410a in A 3.78mm Circular Tube under Normal and Micro Gravity

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Shell-Side Flow Condensation of R410A on Horizontal Tubes at Low-Mass Fluxes

Experimental study on condensation heat transfer characteristics of R410A in short vertical tubes

Experimental Research on Condensation Outside A Horizontal Tube at Low Mass Fluxes

Condensation Heat Transfer and Pressure Drop of R22 in 5-Mm Diameter Microfin Tubes