Abstract:Regulations and restrictions against high global warming potential (GWP) refrigerants have been introduced to encourage the adoption of environmentally friendly refrigerants and mitigate the environmental impact of the HVAC industry. R448A, a zeotropic blend with a GWP of 1390, has recently been proposed as a drop-in replacement for R404A and R410A in commercial systems. In this study, the heat transfer coefficient and pressure drop characteristics of R448A within a multiport mini-channel tube were experimentally investigated. The experimental ranges of the mass and heat fluxes were 100 to 500 kg/(m2s) and 3–15 kW/m2, respectively. Additionally, the range of quality from 0 to 1 was considered at two fixed saturated temperatures of 3 and 6 °C. The heat transfer coefficient increased with mass flux. Under low mass flux condition, the heat flux increased the heat transfer coefficient, but there was no noticeable effect of the saturated temperature on the heat transfer coefficient. At high mass flux, heat flux had no major effect on heat transfer, while a decrease in the saturated temperature was found to increase the heat transfer coefficient. Moreover, the pressure drop increased with an increase in the mass flux and vapor quality, whereas the heat flux did not affect the pressure drop. The heat transfer coefficient and pressure drop performance of R448A was compared with that of R410A inside the same tube. Finally, correlations for heat transfer coefficient and pressure drop were proposed for the prediction of heat transfer coefficient and pressure drop in practical applications.

Experimental Investigation on Pressure Drop of R22 and R410a during Condensing Process in Microtubes

Experimental investigation of condensation heat transfer and pressure drop of R22, R410A and R407C in mini-tubes

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

Experimental Investigation on Evaporation Heat Transfer and Pressure Drop Characteristics of HFC-161 in a Horizontal Smooth Tube

Experimental Investigation on Two-phase Flow Pressure Drop of R22 During Condensation in a Rectangular Microchannel

An Experimental Investigation of Pressure Drop in Two-Phase Flow during the Condensation of R410A within Parallel Microchannels

Condensation heat transfer and pressure drop characteristics inside smooth and enhanced tubes with R410A and R32

Experimental research on refrigerant condensation heat transfer and pressure drop characteristics in the horizontal microfin tubes

Heat transfer and pressure drop during condensation of R22 in microfin tubes

Numerical study on heat transfer and pressure drop characteristics of R410A condensation in horizontal circular mini/micro tubes

Evaporation Heat Transfer and Pressure Drop of R161 in A 7 Mm Micro-Fin Tube

The Influence of Oil on Pressure Drop of R410A Flow Condensation in Small Diameter Microfin Tube

Experimental study on pressure drop of R32, R152a and R22 during condensation in horizontal minichannels

Experimental Investigation of Two-Phase Flow Boiling Heat Transfer Coefficient and Pressure Drop of R448A inside Multiport Mini-Channel Tube

Condensation heat transfer and pressure drop of r134a in horizontal micro-scale enhanced tube

A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels

Experimental Investigation on Condensation Heat Transfer in Horizontal Microfin and Smooth Tube with Refrigerant R22

Condensation Heat Transfer and Pressure Drop of R22 in 5-Mm Diameter Microfin Tubes

Condensation Pressure Drop and Heat Transfer in 5-Mm-od Micro-Fin Tubes

Heat Transfer And Pressure Drop During Evaporation Of R22 In Micro-Fin Tubes

Flow condensation pressure drop characteristics of R410A–oil mixture inside small diameter horizontal microfin tubes