Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Experimental Investigation on Two-phase Flow Pressure Drop of R22 During Condensation in a Rectangular Microchannel

An Experimental Investigation of Pressure Drop in Two-Phase Flow during the Condensation of R410A within Parallel Microchannels

Heat Transfer and Pressure Drop During Condensation of R152a in Circular and Square Microchannels

Experimental study on pressure drop of R32, R152a and R22 during condensation in horizontal minichannels

Experimental Investigation on Pressure Drop of R22 and R410a during Condensing Process in Microtubes

Experimental Investigation on Heat Transfer of R1234ze and R22 During Condensation in Minichannels

Experimental Investigation on Evaporation Heat Transfer and Pressure Drop Characteristics of HFC-161 in a Horizontal Smooth Tube

Experimental Investigation on Heat Transfer of R152a during Condensation in a Circular Microchannel

Experimental study on condensation heat transfer of R32, R152a and R22 in horizontal minichannels

Heat transfer and pressure drop during condensation of R22 in microfin tubes

Experimental investigation of condensation heat transfer and pressure drop of propane, R1234ze(E) and R22 in minichannels

Experimental investigation of condensation heat transfer and pressure drop of R22, R410A and R407C in mini-tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

An Experimental Study of R410A Condensation Heat Transfer and Pressure Drops Characteristics in Microfin and Smooth Tubes with 5 Mm OD

Pressure Drop of R134a and R1234ze(E) Flow Boiling in Microchannel Arrays with Single- and Double-Side Heating

Experimental Study on the Flow Condensation Heat Transfer of R290 and R22 in a Horizontal Circular Minitube

A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels

Heat transfer and pressure drop during condensation of low-GWP refrigerants inside bar-and-plate heat exchangers

Evaporation Heat Transfer and Pressure Drop of R161 in A 7 Mm Micro-Fin Tube

Condensation heat transfer and pressure drop characteristics inside smooth and enhanced tubes with R410A and R32

Condensation heat transfer and pressure drop of r134a in horizontal micro-scale enhanced tube