Abstract:A critical link between longitudinal strains exceeding 0.9% and TA2 edge defects was identified. Introducing the concept of "forming window" to evaluate the precision on TA2 cold roll forming control. The increasing application of TA2 titanium profiles in marine and petrochemical industries has spurred in a growing demand for diverse forms, including U‐shaped, rectangular, and tubular thin‐walled profiles. Traditional methods like mechanical subtractive processing and extrusion, despite their prevalence, suffer from high production costs and low efficiency. As a metal sheet forming technology, roll forming stands out for its efficiency, accuracy, and capability of producing complex shapes continuously. Nevertheless, the application of cold rolling to TA2 profiles is challenging primarily due to its low elastic modulus and high yield strength. In view of this, this study employed finite element simulation to analyze the stress and strain distribution during the TA2 roll forming process, aiming to have a better understanding of edge wave defect formation mechanism. Orthogonal experiments were performed to assess the influence of frame spacing, forming speed, roll gap, and downhill amount, on edge wave defects. The findings revealed a predominant influence of the downhill amount. Maintaining the downhill volume at 0.6 times the tube diameter kept the longitudinal strain below 0.9%, effectively mitigating edge wave defects. Implementation of these optimized parameters in an actual TA2 roll forming process confirmed the reliability of the simulations. This study establishes a solid foundation for advancing the TA2 tube cold roll forming process, enhancing the production efficiency of titanium profiles, and shedding some light on current energy conservation and emission reduction.

Analysis and control of feathering defects on surface of cold rolled thin gauge high strength steel

The Causes and Control of Longitudinal Edge Cracks of the Plate

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Analysis on Occurence and Cause of Linear Defectson Cold-rolled Sheet

Analysis and control of inclusion defects on surface of LCAK hot-rolled coil

Analysis On Surface Spots Of 40mn And Improvement Measures

Reason for Edge Cracking of Cold-Rolled 55Mn Strip Steel and the Cold-rolling Control Measures

Analysis on Appearance and Cause of Scale Defects on the Steel Plate Surface

Mechanism of Black Strips Generated on Surface of CSP Hot-Rolled Silicon Steel

Analysis of Surface Sliver Defect on Cold Rolled and Cold Rolled Galvanizing Sheet

Steel Edge Cracking Analysis and Improvement Measures

Precise local deformation control for UHSS thin-walled component in roll forming

An Improved Segmentation Method for Defects Inspection on Steel Roller Surface

Research on the generation and control of high-order flatness during the controlling of titanium strip profile by the intermediate taper roll in a 20-high mill

Study on "Black Line" on the Edge of SPHC Hot-rolled Strip

Formation reason and control measures of surface quality defects of cold rolled steel sheet for galvanization

Study on Defect Analysis and Control Measures of Copper-brittleness of Dual Phase Steel Containing Copper

Numerical and experimental analysis of edge wave defect control during TA2 circular tube cold roll forming

Surface Inclusions and Their Evolution on Strip Rolled on CSP Line and in Following Cold Rolling Process

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

Analysis On Causing Of Cold-Rolled Steel Hole Defect And Improvement Measures