Abstract:Good profile is one of the important control objectives in hot rolling of aluminum plate. However, M-shaped profile defect often appears for wide aluminum plate and W-shaped profile defect often appears for narrow aluminum plate. In order to reveal the formation mechanism of the two typical profile defects, the evaluation indexes of the M-shaped profile defect and W-shaped profile defect are proposed, and the roll-plate coupling deformation model and the roll thermal expansion model are established. The effects of rolling force, bending force and work roll thermal expansion on the profile are analyzed using these models. The results show that the rolling force and bending force has little effect on M-shaped profile defect, and the main reason for this problem is the uneven thermal expansion of work roll. Meanwhile, the W-shaped profile defect is produced under the combined action of the roll thermal expansion and large roll deflection, and the roll thermal expansion is the necessary condition for the formation of W-shaped profile defect. The greater the thermal crown of the roll, the smaller the rolling force and the greater the bending force, the more obvious the W-shaped profile defect. Based on the above conclusions, industrial tests were carried out. By increasing the cooling flow in the middle of the roll, the frequency of M-shaped profile defect decreases from 29.4% to 9.0%. Meanwhile, by increasing the positive shifting of CVC rolls, reducing the bending force, and decreasing the cooling flow of work roll at the edge of the plate, the frequency of W-shaped profile defect decreases from 42.1% to 14.1%. The profiles of the hot rolled aluminum plates are effectively improved by the developed control strategies.

Analysis and control of inclusion defects on surface of LCAK hot-rolled coil

Analysis on Occurence and Cause of Linear Defectson Cold-rolled Sheet

Analysis and control of feathering defects on surface of cold rolled thin gauge high strength steel

Surface Inclusions and Their Evolution on Strip Rolled on CSP Line and in Following Cold Rolling Process

Cause Analysis and Precaution of Striation Defects of St12 Cold Rolled Coil

Analysis On Causing Of Cold-Rolled Steel Hole Defect And Improvement Measures

Formation mechanism and control of a kind of pit-shaped defect in Cf53 rolled products

The Causes and Control of Longitudinal Edge Cracks of the Plate

Study on Inclusions of Titanium-Stabilized Stainless Steel

Formation reason and control measures of surface quality defects of cold rolled steel sheet for galvanization

Investigation of Inclusion in Tin-plate CC Slab of No.1 Steelmaking Plant at Baosteel

Reason for Edge Cracking of Cold-Rolled 55Mn Strip Steel and the Cold-rolling Control Measures

Study on "Black Line" on the Edge of SPHC Hot-rolled Strip

Cavity Defect Control on Hot-Rolled Strip of SS400 Steel Produced by FTSC in Tangsteel

Analysis of Surface Sliver Defect on Cold Rolled and Cold Rolled Galvanizing Sheet

Characteristics and Hereditary Harm of the Surface Inclusion in Cast rolling Aluminum Strip

Characterization of Nonmetallic Inclusions in Low‐Alloyed Steels Using Pulse Distribution Analysis Optical Emission Spectroscopy and Offline Investigation Methods

Analysis and control of surface cracks in a B-bearing continuous casting blooms

Steel Edge Cracking Analysis and Improvement Measures

Quality Control of High Carbon Steel for Steel Wires

Formation mechanism and control strategy of M-shaped and W-shaped profile defects in hot rolling of aluminum plate